answersLogoWhite

0

An SNDR valve, or "Smart Non-Destructive Readout" valve, is a type of valve used in various industrial applications for controlling fluid flow. It typically features advanced monitoring and diagnostic capabilities, allowing for real-time data collection on valve performance without interrupting the flow. This technology enhances efficiency and helps in predictive maintenance by providing insights into the operational status of the valve system.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Where Refrigeration is a king valve?

I assume you meant to say "Where is a king valve in refrigeration?" Anyhow, it is usually located downstream from a liquid line receiver.


What is meant by a valve spring compressor?

A valve spring compressor is used to remove collets in a car. The tool compresses the valve springs in the cylinder head of the car allowing the collets to be removed.


What is meant by a two chambered part?

2 areas separated by something like a valve.


What is the purpose of a closed heart valve?

A closed heart valve is meant to prevent backflow of blood in the heart. There are valves that separate the atria and ventricles, and valves that separate the ventricles and arteries.


If mitral valve does not close properly which circulation is affected?

The systemic - as the blood flow that travels through the mitral valve is the oxygenated blood meant for the tissues in the body.


What is Difference between relief valve and safety valve?

Relief valve always position in the suction line in oreder to relief the extra pressure, while safety valve is always placed at discharge line to release excess pressure.I would take that one step further by stating that a " RELIEF VALVE" is one that is "meant" to be lifted off its seat, as opposed to a "SAFETY RELIEF VALVE" which is not!DIFFERENCE BETWEEN RELIEF VALVE AND SAFETY VALVE:1. Releif valve is applicable in the fluid system.safety valve is applicable in the gaseous system.2.Relief valve opening is directly proportional to the pressure rise.Safety valve opening is will happen at after reaching the setpressure.3.Mode of relif vlave line is again connected to the suction.But in the safety valve is just vent-out there is no connection tosuction.


What is meant by A 216 WCB ENP in ball valve?

(ASTM) A216 WCB is the specification for the cast steel the valve is made of. ENP might be a foundry or pattern code. ENP is the abbreviation of Electroless Nickel Plate demonstrating the coating of BALL.


Can you help me with this water heater leak please?

If the tank, shut the water off and drain with a hose on the drain faucet on the bottom of the tank. The pressure relief valve can be replaced (however a PRV is meant to drip, it has to expand.), so can vacuum breakers and the TP valve.


What is meant by the term valve lead in the motor industry?

The term "Valve Lead" best describes the amount in degrees in which a valve will open before its desired stroke begins The amount of Valve lead can be influential in the amount of air being drawn into the engine. If the inlet valve is opened before the piston has reached TDC on the exhaust stroke it will increase the amount of air going in for the induction stroke. This is also true if the Exhaust valve is opened before BDC on the power stroke the exhaust gases will get a head start in leaving the cylinder allowing more space for inlet gases to enter.


What is meant by valve hunting?

Ideally, the valve should settle into a single position once setpoint is reached. A hunting valve over-controls, or goes too far, then reverses in an attempt to the correct overshoot, but goes too far, reverses direction again, and constantly repeats this cycle. A hunting valve results in poor control, and prematurely wears out the valve's mechanical parts. Hunting is usually indicative of loop gain too high (PID gain + process gain), or a valve that is oversized for the intended flow, or noisy input signal, or a PID integral term too small.


What is meant by eustachius valve?

The Eustachian valve is a remnant structure in the heart that is sometimes present in fetal development but typically regresses before birth. It is a flap of tissue located in the right atrium near the opening of the inferior vena cava. In some cases, the Eustachian valve can be associated with certain congenital heart abnormalities.


What is Valve pocketing?

Valve pocketing is when a valve is hammering the valve seat.mostly due to miss adjusted valve spring/wrong valve spring/to strong of a valve spring or valve stem to short.Makes the valve seat deeper.