0
A clunk from park to reverse in a vehicle often indicates a potential issue with the transmission or drivetrain. This noise can result from worn or damaged components such as the transmission mounts, universal joints, or internal transmission parts. Additionally, low Transmission Fluid levels or fluid contamination can also lead to harsh engagement between gears. It's advisable to have the vehicle inspected by a professional to diagnose and address the issue before it leads to more serious problems.
What else can I help you with?
I have a 2002 Chevy Malibu 3.1 engine what causes the transmission to clunk from park to drive or reverse when it warms up. I already replaced the trans but it still does the same?
could be bad mounts on either the tranny or engine?
Why does your automatic transmission clunk when sliding shifter past reverse into park and lurch when you turn ignition off sometimes?
i would make sure that the engine is idling at the right rpm cause to fast of rpm can cause that for sure
I have a 2002 Chevy Malibu with a 3.1 eng automatic trans.My question is What causes the trans to clunk when shifting from park into drive or reverse?
The rubber isolators in the engine mounts have worn out or the CV joints in the drive shafts are worn out.
Why does your 1989 Bronco II clunk when shifting and grind when engaged in first and reverse?
bad synco rings
What is causing my 1996 Saturn SL2 to clunk when shifted into reverse?
sounds like a motor or transmission mount is your likely problem
What are the symptoms of a busted motor mount?
YOU WILL FEEL A CLUNK WHEN THE VEHICLE IS PLACED IIN REVERSE OR DRIVE AND IS ACCELERATED WITH THE BRAKES DEPRESSED
What would cause a 1992 Buick Regal to clunk when put in reverse gear?
Worn trans or diff parts. If it gets worse, have it looked at.
What does a bad universal joint feel like on a s10 truck?
when you change directions from forward to reverse it makes a clunk sound and there is a slit delay in movement.
Chevy avalanch makes a clunk when put into reverse?
it could possible be the U-Joint which is a cheap and easy fix. it's connected to your drive shaft.
Expedition clunk noise in reverse when applying brakes?
Pull the rear wheels off and check the brakes. Something may have broken or fell apart.
When was Reverse Cowgirl - South Park - created?
Reverse Cowgirl - South Park - was created on 2012-03-14.
What would make a 1993 Pontiac grand am clunk when you put it in reverse and sometimes tick underneath while driving?
If the ticking is in time to wheel speed and most noticeable on turning I would suspect an outer CV joint. An inner axle joint might clunk when shifting into reverse. Maybe they're on the same axle. Other possible causes of clunking are worn-out motor mounts.
