Connecting two flexes to the same plug can be dangerous because it increases the risk of overheating and electrical fires. Each flex is designed to carry a specific load, and combining them can exceed the plug's current rating. Additionally, if one of the flexes experiences a fault, it could create a hazardous situation for both circuits. Properly rated equipment and outlets should always be used to ensure safety.
The Wires are of different lengths. the shorter cable will connect to the closest plug and the longer cable to the outer plug. technically since they both run off the same coil they will ignite at the same time.
A 1995 is OBD1 not 2. The plug is the rectangular plug under the dash on the driver side. It is not the same style plug as an OBD2 plug.
put the three colored cords in the same colors on the tv and the power cord in the plug
same as every other device just plug the usb and it will be recognized for sure
That is potentially dangerous and should never be done. See an electrician about this problem.
Disconnect the battery, and remove the spark plug wires one by one. Replace the spark plug wires in the same order, ensure the connection is firm, and connect the battery.
Distributor has a center conductor that links to the coil via a wire the same size as your spark plug wires..
most fax machines have two plug sockets on the back, one for the phone line the other for connecting the phone. Just plug the phone into the fax machine.
The calf muscle on the back of your tibia and fibula bones, along with a few small ones in your foot itself that I'm not sure of the name.Your shin flexes and your calf contracts. THis works the same when pointing your foot.
Plug it in and you should see a success dialog box. Click 'Yes' to activate print mode.
It is dangerous because with capacitive load line voltage will increase which cause the line voltage difference and it will not satisfy the parallel operation of the same voltage rating.
To connect two guitars to a single amplifier using a Y cable guitar, simply plug the two guitars into the two ends of the Y cable, and then plug the single end of the Y cable into the input of the amplifier. This allows both guitars to be played through the same amplifier at the same time.