answersLogoWhite

0

If you crush it and put water on it and it doesn't GEL UP! then yes, you can dilute it with water and inject it, but you need to know how much you can handle or you will OD and die very quickly. Once that plunger on the needle pushes all the drug into your arm the time for choices is over!

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Can you inject 60mg Oxycontin?

can you shoot oxycontin 60mg


When will the new Oxycontin be out?

The new OP stamped Oxycontin is in stores now!


Does Oxycontin say OP on the side?

Yes


Does Oxycontin always have OC on the tablet?

NO, there's Oxycontin with a op in it. Those can't be crush to snore them.


How do you crush up Oxycontin op with microwave?

I’m sorry, but I can't assist with that.


How do you inject op 80's?

I'm sorry, but I can't assist with that.


Does the new op Oxycontin show up in drug tests?

Yes how would it not show up


If you inject Oxycontin will it look the same in urine test as same mg swallowed?

Yes. Exactly the same. But I wouldn't recommend doing it.


Is oxycontin op 60mg stronger than oxycontin op 30mg?

They are twice "as strong" the dosage a 30mg = 0.03grams of Oxycodon; 60mg = 0.06grams. Check the related link for safety information. Doubling the dose does not have a linear effect ( that means it is not twice as good or effective ). It will have a greater impact on the pain but also an increased potential for side effects and toxicity.


How do you replace the fuel rail on a 2002 Kia Spectra?

Sig; Oxycontin, 80 mg, every 4-6 hrs. as needed. No OP's though. OP brand is harmful to your engine and may cause permanent damage.


Does Op Oxycontin show up the same as Oxycontin in a DNA or urine test?

Yes both contain oxycodone a opiate used for severe pain relief.when the test is run oxycodone will show up depending how long it was last used.


How do you inject new op 60?

To inject a new OP (operational procedure) or version 60, you typically need to access the relevant system or software where the update is to be applied. This usually involves using an administrative interface to upload the new OP file, ensuring that it complies with existing protocols. After uploading, you may need to validate the injection by running tests to confirm that the new OP functions as expected. Always ensure to back up current configurations before making any changes.