0
What else can I help you with?
Where can you get Oxycontins in New Orleans?
anywhere
Is there a coating inside a gas tank?
Yes there is. There are products that will remove the coating. It will allso remove paint if it contacts the finish.
How do you remove clear coatings from paint?
you have to remove the clear coating
Can you pour concrete on a concrete floor with an epoxy coating?
You must remove the old epoxy coating before pouring the new floor, for otherwise there will be no bonding. If the epoxy coating is thin (e.g, paint) then it may be possible to remove it by hand sanding. If it is a thick coating, then sandblasting is probably the best method. In either case, appropriate dustmasks and other safety precautions are essential. Good luck
How do you remove the protective coating on the copper bottom of your new pan?
To remove the protective coating on the copper bottom of your new pan, boil water and baking soda in a container large enough to fit the bottom portion of your pan. Use three teaspoons baking soda per quart of water. Let your new pot soak in the baking soda and water solution for about 20 minutes. The protective coating should begin pealing off by then.
How do you remove the coating from chipboard?
To remove the coating from chipboard, you will need to sand the area. This can be achieved with the use of an electric floor sander and fine grit sandpaper.
Q1- please tell you how to remove galvonic metal coating from sensitized paper with affecting the original print under coating?
Q1:- please tell me how to remove galvonic metal coating from sensitized paper with affecting the original print under coating Q2:. please tell me how to remove iodine+ black mixture of vasaline from sensitized paper with out affecting the original print under coating
Can you snort tramadol an 627?
Yes u can but its best to remove the coating off first with a wet paper towe,if u dont remove the coating first it will burn,if u do remove it ,it dont burn and the buzz is alot better
You are scientist trying to understand if one type of coating protects metal better than a new coating you have developed You cover five metal blocks with the new coating and another five with the o?
Experimental group
How do you remove non stick coating from glass?
One way to remove non-stick coating from glass is by soaking the glass in a mixture of warm water and dish soap to loosen the coating. Then, use a non-abrasive scrubbing pad or sponge to gently scrub off the coating. Rinse the glass thoroughly with clean water once the coating is removed. If this method does not work, consider using a commercial glass cleaner or stove cleaner specifically designed to remove stubborn residues.
How do you remove coating from pills?
To remove coating from pills, you can crush the pill into a fine powder using a mortar and pestle or a pill crusher. Once crushed, mix the powder with a small amount of water or food for easier ingestion. Alternatively, if the pill is enteric-coated, it's essential to consult a healthcare professional before attempting to remove the coating, as this can affect the medication's efficacy and safety. Always follow medical advice for specific medications.
Do you need to etch the existing epoxy floor before you apply the new epoxy paint?
Etching only benefits bare concrete floors. If you want to ensure that your new coating will adhere to your old coating, blend enough of the epoxy to cover a single square foot section, let it cure for a week, then check the adhesion by scoring a cross-hatch design in the new coating, put some duct tape across the scored area, then quickly pull up the tape. If the epoxy comes up, then you will have to remove the old coating prior to recoating the floor.
