Sus forks just about never have eyelets for fender mounts. Either you stick them on by inserting an expander type fastener included with the fender into the bottom of the steerer tube, or you do something less precise with cable ties around the crown of the fork.
take out the screws on the inside
start looking for screws.
Unplug the front fender tip light (if applicable on your Road King model) and loosen the nuts on the four allenhead screws that hold the fender to the fork sliders. Carefully remove the four screws while supporting the fender, then lift the fender up and out from between the fork sliders. To prevent scratches you might want to tape rags to the bottom of the fender, which is the widest part.
Take out the screws that hold it on.
There should be a number of screws on the inner fender. Using a floor jack, lift the car and remove the front wheel. Look to see if any screws are missing and replace them.
Removing the rear fender from a 2007 Vulcan 900 is not hard at all. Simply remove any screws or fasteners and wiring that are holding the fender in place. There are tutorials for removing the fender online at YouTube.
I looked at my remote filter on my 93 S10 Blazer and it is bolted to the inner fender which shouldn't need to be removed to remove the fender.
There should be some screws and nuts and bolts.
make sure all the screws are on the faceplate right and it should be
Remover the socket head cap screws from the fender struts and remover the tail light/ turn signal wiring from the tabs underneath the fender and you should be home free.
The right front fender on the 2003 Honda Civic is held on by several mounting bolts and screws. Raise the hood and loosen the bolts. Raise the vehicle and remove the wheel to reach the bolts in the wheel weld. Remove the bolts inside the door hinge and the screws on the bumper. Remove the fender.
There are seven steps on how to remove a fender from a 95 Dodge Ram 1500. Some of the step-by-step instructions are remove the screws that hold the wheel well to the fender, remove the bolts from the wheel well fender, and then remove the bolts that attach the fender to the rocker panel flange.