0
When roughing in water and sewer into a new building do they have to be separated by a certain distance?
That depends alot on your location and what codes your jurisdiction has adopted. From the 2006 International Plumbing Code, "water service pipe and the building sewer SHALL be separated by 5 feet of undisturbed or compacted earth." There are exceptions, 1. "the required separation distance shall not apply where the bottom of the water service pipe within 5 feet of the sewer is a minimum of 12 inches above the top of the highest point of the sewer and the pipe materials conform to Table 702.3. 2. water service pipe is permitted to be located in the same trench with a building sewer, provided such a sewer is constructed of materials listed in Table 702.3. 3. the required separation distance shall not apply where a water service pipe crosses a sewer pipe, provided the water service pipe is sleeved to at least 5 feet horizontally from the sewer pipe center-line on both sides of such crossing with pipe materials listed in Table 605.3, 702.2, or 702.3." So, no, there is no minimum separation IF the materials you are using bear the correct ASTM #. (Your building sewer pipe will probably have ASTM F 891 stamped on it.)
Add your answer:
Earn +20 pts
How does the base isolation system work?
This is when a building is separated from the ground that it is built on by large plates. One plate is secured to the ground and the other is secured to the bottom of the building. These plates move a certain distance when the ground shakes.
A building is 120 feet high. at a certain distance away from the building. an observer notices the angle of elevation to the top of the building is 41 degrees. how far is the observer from the base of the building?
6
What is roughing off a horse?
When you turn out a horse or pony to give them a break/holiday for a certain amount of time
What is called the ratio of magnitude of the forces acting on each point charge separated by certain distance is?
The ratio of the magnitude of the forces acting on each point charge separated by a certain distance is called the electric field strength. It is a measure of the influence that a source charge has on other charges in its vicinity. Mathematically, it is given by the force per unit charge.
How close to a utility pole can you build a structure?
Building codes typically require structures to be set back a certain distance from utility poles to ensure safety and maintenance access. This setback distance can vary by location and is usually specified by local building regulations. It's best to check with your local zoning or building department to determine the specific setback requirements in your area.
What is the maximum distance an outlet can be from a bedroom door?
There is no specific maximum distance for an outlet from a bedroom door as it can vary depending on local building codes and regulations. However, typically outlets are required to be within a certain distance of a doorway, such as 6 feet, to ensure accessibility and convenience. It is best to consult local building codes or consult with a professional electrician for accurate information.
At a certain distance the angle of elevation to the top of a building is 60 From 40ft further back the angle of elevation is 45 Find the height of the building?
Angle of elevation: tangent angle = opposite/adjacent and by rearranging the given formula will help to solve the problem
What does a single point on a distance time graph show?
The distance from start at which a certain object is located at a certain time.
What are forces that always act in equal but opposite pairs?
If the equal and opposite forces are separated by a certain distance they are called as couple. If the equal and opposite forces are not seperated by a certain distance their resultant is zero as per Parallelogram Law of Vector Addition.
A discrete random variable can have only certain clearly separated values?
true.
Measure of change in elevation in a certain distance is called what?
The measure of change in elevation in a certain distance is called slope. It is typically expressed as the ratio of the change in vertical height to the horizontal distance between two points on a surface.
What is the term for the distance an object travels in a certain direction in a certain time?
it is its speed
