answersLogoWhite

0

What else can I help you with?

Continue Learning about Industrial Engineering

Sources of domestic industrial and agricultural wather pollution?

Domestic pollution is caused by landfill waste seeping into the groundwater flow. Agricultural pollution comes from farms. It occurs when the farmers spray their land with pesticides and fertilisers which then run off the land when its raining , into nearby water sources . This pollutes the water and the marine life living in it. :)


Why are electromagnets used in recycling factories?

Because they can be turned off and on again(unlike permanent magnets) they can pick up steel and other magnetic materials that can be recyled and more them to seperate places. Therefore seperating the rubbish.


What were typical late 19th century factories like?

Workers lived in tenements which were usually very crowded, small, and dirty. They often had 3 to 4 families per room. Waste was put in the backyard in a trench, and there was no indoor plumbing.Factory conditions were terrible. Safety was not high on the list, for factories usually only had one exit. This helped regulate who was coming into and leaving the factory, but in the event of a disaster, would be a death sentence to anyone trying to leave. Factories also had no fire escapes on windows, and windows were usually few and far between. Workers also wore a minimum amount of clothes, for factories were hot, especially steel mills, were workers often times worked naked with scalding hot metal only feet away.Women earned half of what men earned.Women and children were large parts of the workforce.


What is the minimum recommended tilt angle on a forklift?

Tilt is always "back" - toward the machine - so the load won't slide off the forks. It's recommended to tilt the load back as far as can be done safely. If you have a stable pallet, the best thing to do is tilt as far back as the machine will let you. More important is load height. Until you absolutely MUST lift the load, keep it about four inches off the floor.


How is iron refined?

Iron is refined by a blast furnace. A furnace is filled with iron ore, coke (which is charcoal made from coal) and limestone. Huge amounts of air are blasted into the furnace, the calcium from the limestone combines with silicates (which are minerals containing silicon and oxygen) to form slag (which is run off ore from the furnace). A layer of liquid iron collects under the slag, at the bottom of the furnace. The liquid iron is periodically let out to cool. Charlie

Related Questions

Who are the culprits of air pollution in Singapore?

The main culprits of air pollution in Singapore are automobiles, trucks, and factories. Most of the pollution given off by this technology is not regulated to much degree.


What are the trees good for polluted cities?

cars and factories put off a lot of pollution the trees filter most of that pollution out of the air and makes it safe to breathe


What steps do you needed to stop the air pollution?

For factories to not give off smoke or fumes into the air. ... hope that is what you wanted / needed


What are 2 cause of water pollution?

There are many, but two are: Waste water run off from factories and manufacturing plants, and humans.


What are 2 dangerous causes of water pollution?

There are many, but two are: Waste water run off from factories and manufacturing plants, and humans.


What is the pollutant is responsible for the killing of trees?

pollution from big industrys and factorys also some cars let off pollution that can harm trees.


What are three problems of water pollution?

Silt is a major problem. Run-off (oil and fertilizer) from roads and farms is another. Unregulated or illegal waste from factories is another.


How does a diaper work?

I diaper has sticky things you peel off the backs and put the sticky part Against the other side of the diaper and your good to go


How do you wash the Kushies Girl Swim Diaper?

The cloth diaper itself is throw away and the diaper covering itself can we wiped off with a clean moist towel.


What do factories let off into the air?

Factories can release pollutants such as carbon dioxide, sulfur dioxide, nitrogen oxides, and particulate matter into the air. These emissions can contribute to air pollution and have negative impacts on human health and the environment.


How can I prevent my toddler from taking off their diaper and peeing on the floor?

One way to prevent your toddler from taking off their diaper and peeing on the floor is to use a diaper that fits securely and is not easy for them to remove. Additionally, you can try to keep a close eye on your toddler and redirect their attention when you notice them trying to take off their diaper. Consistently reinforcing positive behavior and providing praise when they keep their diaper on can also help prevent this behavior.


How can I effectively handle a toddler taking off their diaper?

When a toddler takes off their diaper, it is important to calmly and gently redirect their behavior. You can try distracting them with a toy or activity, and also consider using a one-piece outfit or diaper cover to make it more difficult for them to remove their diaper. Consistency and positive reinforcement can help reinforce the desired behavior of keeping their diaper on.

Trending Questions
What is the Rockwell Hardness for H13 steel? Can needs of industry and environment ever be balanced? Two principals that are the basis of modern manufacturing are the use of interchangeable parts of? What does imdg stand for? What is a hand trolley in the construction industry? Location of cotton textile industry in India? Who is known as the 'Father of the modern assembly line'? Give examples of how an interior designer might benefit from a knowledge of diffuse reflection.Choose an example of direct and indirect light in your home. Briefly summarize their effectiveness.? What is the symbol for First Trust Energy Infrastructure Fund in the NYSE? Why so you think new ge ceo Jeff immelt has revised the work out concept? How can having more work-in-process inventory improve the efficiency of a process? What opened a textile mill that combined spinning and weaving? I'm working with a private organization related to customize printing industry, they usually use really ancient methods for printing, all employs are Sick And Tired Of Doing Booklet printing The Old Way. any suggestion for upgrade? The inventory valuation method that tends to smooth out erratic changes in costs is? Explain how the assembly line helped american industry? How is plastic aluminized? Where can I find PLC training classes in Columbus, OH? Just-in-time manufacturing is a production system that pulls products through the manufacturing process on the basis of market demand? What is front end and back end logistics? What does en indicate on a welding rod?