To change a well pump, you will need to first turn off the power to the pump. Then, disconnect the old pump from the water system and remove it from the well. Install the new pump in the well and reconnect it to the water system. Finally, turn the power back on and test the new pump to ensure it is working properly.
when changing the water pump it is also adviseable to change the timing belt as well.
the oil pump is in the oilpan but in order to change it you will have to to the timing as well
You might as well change the Thermostat because it is comparatively inexpensive, but test the water pump to see if it needs to be replaced.
No, the engine doesn't have to be pulled to change the water pump.
its called the sending unit which is connected to the fuel pump you have to change fuel pump go ahead and change the fuel filter as well
The pump is located under the reservoir for the fluid. Two screws hold the reservoir in place. Unscrew them, lift the reservoir and you will see the pump on the attached to the reservoir. It is easy to replace. But empty the reservoir the best you can before you change the pump. And change the pump filter as well, since this being clogged is likely what caused the pump failure. It located at the same area and is part of the replacement pump.
Oil pump change
well you have to buy a haynes manuel and it explains it in verry good detail
"How do you change steering pump on 2005 aveo?
An oil pump on a 1994 Honda Civic is found in the bottom end of the engine. To replace the oil pump the engine will require a rebuild as the crankshaft will have to come off as well.
Your pump and filter are rated at a certain psi. To change that you would have to change the pump and maybe the filter.
The gas tank has to come out to change it as the pump is in the tank.