To turn on a gas fireplace using a key, locate the gas valve on the fireplace and insert the key into the valve. Turn the key clockwise to open the gas flow. Then, use the fireplace's ignition switch or a long lighter to ignite the gas. Adjust the flame as needed for desired heat.
To turn on a gas fireplace using the wall key, insert the key into the keyhole on the wall near the fireplace. Turn the key clockwise to open the gas valve and allow gas to flow to the fireplace. Then, use the fireplace's ignition switch or button to ignite the gas and start the fire.
To turn off a gas fireplace using the wall key, locate the key on the wall near the fireplace. Insert the key into the keyhole and turn it clockwise to shut off the gas supply. Make sure the flames are completely extinguished before removing the key.
To light a gas fireplace using a key, first locate the gas valve key near the fireplace. Insert the key into the gas valve and turn it to the "on" position. Then, use a long lighter or match to ignite the gas at the burner. Be sure to follow the manufacturer's instructions and safety guidelines when lighting the gas fireplace.
To turn on the fireplace, insert the key into the designated keyhole and turn it clockwise. This will ignite the fireplace and start the flames.
All gas fireplaces have to have a shut-off valve within 10' and that will turn so the key or the handle is parallel to leave gas on and perpendicular to turn gas off. The valve inside the fireplace turns but not indiscriminately. The inner valve will turn to the pilot setting and depress to light the pilot. Once the pilot os stable the knob will un-depress and turn to the On position. For a manual valve this will turn on the gas flow to the main burners. If using a switch or remote turning the valve to On leaves the fireplace valve in a Ready position so the switch or remote will turn on the gas.
turn key to on. press gas pedal three times. turn off key. this resets light. turn key to on. press gas pedal three times. turn off key. this resets light.
To turn on a sprinkler system using a key, locate the main control valve for the system and use the key to turn it to the "on" position. This will allow water to flow through the system and activate the sprinklers.
Turn key to on position for a minute or so then off. Turn key to start and pump gas. This gives fuel pump time to send gas to engine.
turn key on and let the fuel pump have time to push gas up to the motor. turn key on but dont start for about a minute. Make sure you put gas in first.
To restart a Jaguar after running out of gas, turn the key on and off a few times. Turning the key on will signal the fuel pump to pump gas into the carburetor.
turn key on, hit gas three times, turn key off ,start truck it should be cleared
take the gas cap off the gas tank and have someone listen for it to turn on as you turn the key onto start.