0
What else can I help you with?
Can you get polyurethane poisoning from a piece of furniture that has been painted with polyurethane?
no dont be stupid
Does a small funnel will appear to indicate a filter has been applied to data in a table?
Yes
Can you apply epoxy over a surface that has been previously coated with water-based polyurethane?
Yes, epoxy can be applied over a surface that has been previously coated with water-based polyurethane. However, it is important to properly prepare the surface by sanding it lightly and cleaning it thoroughly before applying the epoxy to ensure proper adhesion.
Can you apply water-based polyurethane over a surface that has been previously coated with oil-based polyurethane?
No, it is not recommended to apply water-based polyurethane over a surface that has been previously coated with oil-based polyurethane. The two types of polyurethane do not adhere well to each other, which can lead to issues with the finish. It is best to stick with the same type of polyurethane for recoating.
Can I apply water-based polyurethane over a surface that has been previously coated with oil-based polyurethane?
No, it is not recommended to apply water-based polyurethane over a surface that has been previously coated with oil-based polyurethane. The two types of polyurethane do not adhere well to each other, which can lead to issues with the finish. It is best to sand down the surface and remove the oil-based polyurethane before applying the water-based polyurethane.
Can you apply polyurethane over epoxy?
Yes, you can apply polyurethane over epoxy as long as the epoxy has fully cured and been properly prepared for the polyurethane application.
How do you make tennis ball from polyurethane?
There is no evidence of a ball been made from polyurethane. There are polyurethane foam balls, but unfortunately no tennis balls. The process is likely to be the same as a normal tennis ball, the only difference being that the rubber in the ball is replaced by polyurethane.
What is polyurethane foam insulation?
It is polyurethane that has been expanded with air when liquid, and formed into sheets, often 2-3 inches thick.
How do you repair a sun faded oak table?
Slightly abrade the varnished surface with sandpaper. Apply a gel type stain with a brush then soften brush marks with a dry brush. Top with two coats polyurethane varnish. Or strip old finish and start from scratch.
Can you spray clear polyurethane over paint?
what kind of paint?? How long has the original paint been on there? Many times, the "vehicle" (solvent) in the polyurethane will cause the existing paint to curdle or wrinkle if it is a water based/latex paint. If it has been on there a long time though, you might be able to get away with it. See if you can test a small spot that is not exposed or visible first. Even if it "tests" OK, it still might have a tendency to pull the existing paint up when you get it on a large area, so be careful
Why don't your hardwood floor shine?
If your hardwood floor is not shining, it might need some polish. Or, it might just be old. I suggest investing in a new hardwood floor if yours is so ancient that it has lost its ability to be lucent. Or you can have your floors refinished. If they have been sanded recently, you might have a satin sheen in the polyurethane that was applied. If this is the case, all you have to do is re coat it with a semi gloss or gloss polyurethane.
In GCSS- Army when an ascending or descending sort has been applied to a data table what indicator in the table is used to identify the column of data used to establish the sort?
Not sure
