To thread PVC pipe for Plumbing purposes, you will need a pipe threader tool specifically designed for PVC. First, cut the PVC pipe to the desired length using a saw. Next, apply a lubricant to the end of the pipe to make threading easier. Insert the pipe into the threader and turn the handle clockwise to create the threads. Be sure to thread the pipe to the appropriate depth for a secure connection.
To thread a PVC pipe, you can use a pipe threading tool to create grooves on the end of the pipe. This allows you to screw on fittings or connectors securely.
It depends on the size of PVC. For smaller PVC you can buy fittings that glue onto the PVC and allow a thread x barb fitting to be installed. For larger pipe you should get a brass compression fitting that clamps down on the PVC and adapts to a thread x barb fitting.
No, do not use glue. Use teflon tape or pipe dope on the threads. You should also make sure you always put the male PVC thread into the female metal thread. If you do it the other way you will tend to split the PVC fitting when you tighten the threads.
Not plumbing pvc pipe, but pvc pipe made especially for wiring.
The advantages of using PVC pipe instead of cast iron pipe for plumbing systems include lower cost, easier installation, resistance to corrosion, and lighter weight.
Pipe dope and/or teflon tape
The best ways to connect 1/2 inch PVC pipe for a plumbing project are using PVC solvent cement or PVC primer and cement. These methods create a strong and watertight bond between the pipes.
A 1/2 PVC elbow is used in plumbing installations to change the direction of the pipe at a 90-degree angle.
Not in most civilized plumbing codes
C x M adapter C x F adapter PVC x F adapter PVC x M adapter or Thread if your really using "pipe" in lieu of "tubing"
To effectively connect PVC pipe joints for a secure and leak-proof plumbing system, clean the pipe ends and fittings thoroughly, apply PVC primer and cement to the surfaces, insert the pipe into the fitting, and hold them together firmly for a few seconds to allow the bond to set.
Use teflon tape with a little pipe dope. If you don't ever have to take apart again then you can use glue which you are calling cement