The power company will know if you pull your meter because they have systems in place to monitor and track electricity usage. If the meter is removed, it will be detected as a disruption in the flow of electricity, prompting the power company to investigate the situation.
I was site a background to my company and i pull something but I don know what did I pull so can you help me ?
It is illegal and dangerous to pull an electric meter without proper authorization and training. Only licensed electricians or utility company personnel should handle electric meters to ensure safety and compliance with regulations.
You do not remove the electric meter from a house. Ever. You could be electrocuted or have an explosion in front of your face, putting molten metal through you. You must call the power company and they will send a properly trained and properly safety-equipped technician to remove the meter from the house. Even the fire department is no longer authorized to "pull a meter". They would rather have your house burn down than risk the life of a firefighter making an attempt to pull the meter, even with firefighting protective equipment. Do not attempt to remove an electric meter from a house.
Pull it out an look at it. Most of the time you can easily see it is blown. If not check it with an ohm meter.
There isn't a database that I know of that records this information.
In North America you don't. If the utility company catches you tampering with their meter you could be subjected to a fine and in extreme cases a disconnection from their supply. Once the seal is broken and the meter reader sees the broken seal it is reported to the utility company right away. If you need to get it removed for legitimate reasons call the utility company and they will remove it for you. In certain cases the utility company will allow approved contractors to pull the meter but the contractor has to abide by the utility company's rules.
Extreme power consumption, like a short! Not a safe situation. If you have a meter, check the current flow through the cables. To find out where the power is going, pull ALL the fuses (noting where they went) and then with your meter, replace them one at a time.
Go to the phone company and ask them to pull the records from then to now.
Manual has better pull power.
What do you want to know? Can you use transistors in a Class B push-pull stage? Yes. What else is being asked?
No the service wires need to be upgrade to 3/0 copper or 250 mcm aluminum. This will require a power company to disconnect so you can upgrade the service. These wires are always hot unless the power company disconnects from their source. Do it right pull a permit and upgradeAdditional information:Some meter base boxes include a shutoff/breaker. If you are only looking for additional space inside the breaker panel, and do not upgrade to a higher amperage breaker inside the meter base, you actually CAN use the same wire, provided that it is long enough to reach into the new breaker panel. The breaker of the meter base protects from the over-current condition.If you have the shutoff in the meter base, you will obviously be able to disconnect service while you perform the necessary changes. While you are working on the service, lock-out the meter base access to prevent anyone from turning the power back on.It is still recommended that you pull a permit and work with a qualified electrician.
Yes. Gravitational pull is based on mass. And since the bowling balls have greater mass than the ping pong balls then the gravitational pull would be greater.