0
What is the best way to connect two sections of PVC pipe with a 2 inch PVC coupling?
The best way to connect two sections of PVC pipe with a 2 inch PVC coupling is to first clean and dry the pipe ends, apply PVC primer and cement to the ends and inside the coupling, then quickly push the pipe ends into the coupling and hold them in place for a few seconds to allow the cement to bond.
What else can I help you with?
How do you Connect a 3 inch ABS pipe to cast iron pipe?
Buy a 3" MECHANICAL COUPLING at any hardware or plumbing store. Made of rubber and has hose clamps.
Can you connect a kitchen drain into a 2-inch vent drain?
yes. The kitchen drains are normally 1 1/2 inch so you have enough drain to carry the sink addition.ANS 2 YES there is a standard ABS coupling to do so
How many 6 inch sections can you cut from 1.5 feet?
3 six inch sections
How many eight-inch sections can you cut from a 120 inch board?
120/8 = 15 sections.
How many eight inch sections can you cut from 120 inches?
You can cut 15 eight-inch sections from 120 inches.
What is the best way to connect a microphone with an XLR output to a device with a 1/4 inch input?
To connect a microphone with an XLR output to a device with a 1/4 inch input, you can use an XLR to 1/4 inch adapter or a cable with XLR on one end and 1/4 inch on the other. This will allow you to connect the microphone to the device and ensure proper audio transmission.
How many 12inch sections can you get out 9 foot piece of plywood?
You need to cut a 9 foot piece of plywood into 12 inch sections. Every cut also removes 1/8 inch. How many 12 inch sections can you get out of the 9 foot piece of plywood?
What is the recommended method for connecting two pipes using a 2 inch coupling?
The recommended method for connecting two pipes using a 2-inch coupling is to first clean and prepare the pipe ends, apply pipe joint compound or thread seal tape to the threads of the pipes, then screw the coupling onto the pipe ends tightly using a wrench.
What is 11 inch paper divided into 4 sections?
2.75
You need to cut a 9 foot piece of plywood into 12 inch sections. Every cut also removes 18 inch. How many 12 inch sections can you get out of the 9 foot piece of plywood?
A 9-foot piece of plywood is 108 inches long. If you want to cut it into 12-inch sections, you can theoretically get 9 sections (108 ÷ 12 = 9). However, each cut removes 18 inches in total, so to make 8 cuts to achieve 9 sections, you need to account for the 18 inches lost. This means you lose 18 inches from the 108 inches, leaving you with 90 inches, which can only yield 7 full 12-inch sections (90 ÷ 12 = 7.5). Thus, you can get 7 complete 12-inch sections.
How do you replace 1.5 inch bathtub drain pipe?
With an 11/2 Mission coupling toque to 80 in pounds.
What is the best way to connect a 1/4 inch copper tubing to a water supply line?
The best way to connect a 1/4 inch copper tubing to a water supply line is by using a compression fitting. This fitting allows for a secure and leak-proof connection between the tubing and the water supply line.
