With an 11/2 Mission coupling toque to 80 in pounds.
To replace the drain pipe under a bathtub, you will need to remove the old pipe by disconnecting it from the bathtub and the main plumbing system. Then, install a new drain pipe in its place, making sure to secure it properly to prevent leaks. It is recommended to consult a professional plumber for assistance with this task to ensure it is done correctly and safely.
The purpose of the tub drain shoe in a bathtub plumbing system is to connect the drain pipe to the bathtub and provide a secure and watertight seal to prevent leaks.
You need to check for a clogged pipe .
The standard size of a bathtub drain pipe is typically 1.5 inches in diameter. This size is commonly used to ensure adequate drainage and prevent clogs. In some cases, larger bathtubs or specialized installations may utilize a 2-inch drain pipe for improved water flow. It's important to check local plumbing codes and manufacturer recommendations for specific requirements.
The purpose of a bathtub drain flange is to provide a secure connection between the drain pipe and the bathtub. It helps to prevent leaks and ensures that water flows properly down the drain. The flange also helps to support the drain assembly and maintain the structural integrity of the bathtub.
The purpose of a bathtub drain shoe is to connect the drain pipe to the bathtub and provide a secure seal. It helps to prevent leaks and ensures that water flows properly through the drain system. The drain shoe also helps to support the weight of the bathtub and maintain its stability.
Washing machines pump out a large volume of water and todays standards require a 2 inch drain pipe. Bathtubs generally have a one and one half inch drain. So bathtub drain will have to be increased to 2", including trap and 18 to 24" standpipe to operate correctly, and connected to the closest existing 2" line or larger line. Same 11/2 venting can be used.
To replace a bathtub drain, you will need to remove the old drain assembly by unscrewing it from the drain pipe. Then, clean the area around the drain hole and apply plumber's putty to the new drain assembly before inserting it into the hole. Secure the new drain in place by tightening the locking nut underneath the tub. Finally, test the new drain by running water to ensure it is properly sealed and functioning.
It's not the toilet, there's a blockage in the pipes some where after the drain pipe from the toilet joins up with the drain pipe from the tub.You're going to need to have the pipe snaked.
The cost to replace a cast iron drain pipe can vary depending on factors such as the length of the pipe, the complexity of the installation, and the location of the pipe. On average, homeowners can expect to pay between 1,500 to 3,000 for a professional to replace a cast iron drain pipe.
A 1.5 to 2-inch diameter pipe is typically used for a sink drain.
Probably the wrong size flange. Is the flange a toilet collar? If so the pipe is probably 4 inch.