The best way to cut a cast iron pipe is to use a reciprocating saw with a metal-cutting blade or a snap cutter specifically designed for cutting cast iron. These tools are effective in making clean and precise cuts in cast iron pipes.
To cut a cast iron pipe effectively, use a reciprocating saw with a metal-cutting blade or a snap cutter specifically designed for cast iron. Make sure to wear safety gear, mark the cutting line, and cut slowly and steadily to avoid damaging the pipe.
Use a Barbie head. Sawzall with metal cutting blade to cut through pipe without damaging cast iron pipe.
This takes a while, but should work. Use a hacksaw blade on the inside of the pipe and cut just through the pipe in two or three places depending on the size of the pipe. Once it is cut, you can pry the pieces out of the cast iron body.
To safely and effectively cut a cast iron pipe, you can use a reciprocating saw with a metal-cutting blade or a snap cutter specifically designed for cast iron. Make sure to wear safety gear, such as gloves and goggles, and work in a well-ventilated area. Mark the cutting line on the pipe, secure it in place, and slowly cut through the pipe using the chosen tool. Be cautious of sparks and debris during the cutting process.
Yes, it is possible. Unfortunatly, if you have a cast iron riser, you will have to chip out the concrete to get low enough to cut the riser to install a Clamp-all and a piece of PVC pipe. This might not be possible if you have a short riser. Then you would have to cut the cast iron behind the 90 degree turn. Either way, it's a pain in the butt. Call a plumber. It will be worth it.
Put a cutting blade on it and it shouldn't have water in it when you cut because of the possibility of shock.
You must break or cut the wall at that point. No other option
yes you can do it but you have to use a cast iron cutter, or cicular saw with a carbon friccion to cut arround the pipe. But if the cast iron pipe in in the ground and it's not muveble,, it may break.. so you have to be carefull and when you finish cutting it you put a piace of ABS pipe 1/2 shorter in each side. In order to incert the hob conectors..
how do i cut cast iron
To safely and effectively cut cast iron pipe, use a reciprocating saw with a metal-cutting blade. Wear safety goggles and gloves, and make sure the pipe is securely held in place. Slowly and steadily cut through the pipe, applying gentle pressure. Be cautious of sparks and wear a mask to avoid inhaling dust.
Yes. I have replaced a lot of old leaky cast iron sewer pipe and always use a sawzall. I use regular metal cutting blades. If you don't have the specific blade handy use bimetal cutting blades.
Cut out the old piping and caulk a new cast iron bell and spigot with lead and oakum and test