0
What else can I help you with?
What size drill bit should I use for a 3/8 bolt?
For a 3/8 bolt, you should use a 5/16 drill bit.
What size drill bit should I use for a 1/4 bolt?
For a 1/4 bolt, you should use a drill bit that is slightly smaller in diameter than the bolt itself. In this case, a 7/32 drill bit would be a good choice for drilling a hole for a 1/4 bolt.
What size lag bolt drill bit should I use for installing heavy-duty shelves in my garage?
For installing heavy-duty shelves in your garage, you should use a 3/8 inch lag bolt drill bit.
What type of drill bit should I use for a 3/8 bolt?
For a 3/8 bolt, you should use a 3/8 drill bit.
What size drill bit for a one quarter inch bolt?
For a clearance hole you need a 9/64 drill bit.
What size drill bit should you use to drill a hole that is threaded for a 1by4-20 UNC bolt?
Your meaning is not clear. - If you are going to tap the threads in, use a 7/32 drill bit. If you want a hole that this bolt will slip through, use a 9/32 drill bit.
What size drill bit should be used for an M6 tap?
For an M6 tap, a drill bit size of 5.0mm should be used.
What size drill bit should I use for this project?
The size of the drill bit you should use for your project depends on the size of the hole you need to drill. Check the project specifications or use a drill bit sizing guide to determine the appropriate size for the job.
What size drill bit should I use for a 6 screw?
For a 6 screw, you should use a drill bit that is 7/64 inches in size.
What to do Putting a power steering pump in a 89 S10 truck broke the bolt on the alternator that holds the bracket what to do?
remove alternator and bracket.with a drill bit smaller in size than he the thread on the broken bolt, carefully drill broken part of bolt that is still in engine.then use an" easy out " to remove broken peice.an" easy out" can be purchased with the correct size drill bit if you know the bolt size.
What size drill bit do you need for a piece of conduit?
Depends on the diameter of the conduit. Try for 1/4" larger diameter drill bit.
You want to install a 3 eights lag bolt into steel frame what size drill do you use?
quarter inch drill bit
