The size of wire needed for a hot water heater depends on the heater's wattage and the distance from the electrical panel. It is recommended to consult a professional electrician to determine the appropriate wire size for your specific hot water heater.
The wire size is dependent upon the wattage size of your water heater. The higher the wattage the larger the wire size. A standard 3000 watt heater will use a two pole 20 amp breaker connected to 2C #12 wire.
A tankless water heater should be installed near the main water source and close to the areas where hot water is used most frequently, such as bathrooms and the kitchen. It is important to consider access to gas or electricity, ventilation requirements, and the size of the unit when choosing a location for installation.
A leaking water heater can be very dangerous and should not be used if it is leaking. Also, you should clean the leakage and keep it away from any other electronics.
Assuming you are referring to a 240 volt residential hot water heater you will need to install 10/2 NM cable (Romex) with ground from the service panel to the water heater wired to a 30 amp circuit breaker in the service panel. If you cannot see the water heater from the service panel you will need to install a service disconnect at the water heater.
The efficiency of a water heater is measured by its Energy Factor (EF), which indicates how much of the energy input is converted into hot water. Factors that can affect a water heater's performance include the type of fuel used, the size and design of the heater, the temperature setting, and the frequency of maintenance.
Type your location and water heater in the search or the nearest town and something should come up. I used Melbourne and a bunch of sites came up.
About 100 square feet is the averge room size for a heater to be used.
There are two insulated heater elements that heat the water.
The size of the water pipe from the meter to the house should be determined based on the water flow rate needed for the house. It is recommended to consult with a professional plumber to determine the appropriate size of the water pipe for optimal water flow and pressure.
It's because "hot-water" is a compound adjective, modifying "heater". It's not for heating water, it's for heating a house with hot water. There are many types of heaters that heat water, but only a hot-water heater is used for providing heated water for domestic use. A hydronic boiler also heats water, but it's only for use in radiators.The name "Hot Water Heater" is completely wrong for any use. There is no need to heat hot water. IT has always been "water heater". The term hot water heater has just been used for years because people don't realize the difference. It has always been WATER HEATER.The first answer is jibberish and makes no practical sense at all.
This could either be due to the age or the materials used to make the water heater or the fact that the water heater has not been installed with vacuum breakers causing the geyser to collapse from the inside-out due to incorrect atmospheric pressure within the water heater
Physically yes depending on the size of the boat, by code? consult your municipality. All comes down to what you're willing to pay.