comparing the cylinder pressure and the temperature to a pressure-temperature chart.
A cylinder can be made of almost any material and that material will then make up its volume.
Refrigerant is the material that absorbs heat when evaporating and releases heat when condensing. If not for refrigerant in the system, it would not function. Before refrigerant, other more dangerous gases were used to achieve the same goal, such as propane.
Fake fossils are detected because scientist check what type of material they are made of. Most fake fossils are made of cement or plaster.
The density of the brass block and brass cylinder should be very similar since they are both made of the same material, brass. Density is a physical property that is unique to each material and is determined by the mass of the material divided by its volume. Therefore, as long as the block and cylinder are made of the same brass material, their densities should be close.
Yes, a cylinder can slide along a surface if there is minimal friction present between the cylinder and the surface. The ability of a cylinder to slide is dependent on factors such as surface texture, material of the cylinder, and external forces acting on it.
It is impossible to determine the weight of the cylinder without knowing additional details. Such details include the material which the cylinder is made of, as well as any possible contents of the cylinder.
In a refrigeration system, the evaporator operates by absorbing heat from the surrounding space or material, causing the refrigerant inside to change from a liquid to a low-pressure gas. This process cools the space or material while the warm refrigerant gas is then compressed and pumped back to the condenser to release the absorbed heat.
The heat is released by heat exchangers in the atmosphere.
THE machine consists 3 major cylinders, Plate cylinder, Blanket cylinder and impression cylinder
Made from a Composite Material. Strong light and not able to be detected by the radar.
because the hermatic compressor motor must be compatible with the refrigerant and oil circulating in the system.
In order to Calculate the weight of a hollow cylinder, you need to find out the density of the material of the cylinder first. once you have that, you can use the formulas below Find out volume of material as follows: Volume = Pi * (Outer Diameter of Cylinder)2/4 - Pi * (Inner Diameter of Cylinder)2/4 Mass = Density * Volume( from above equation) Note: Remember that units of Density and volume should be matching.