Windows XP + SP3
XLG Control took over the computer. No icons, no task bar.
I Started Windows in secure mode with command Prompt (F8).
==> regedit
searched for sysguard and delte the last entry
searched for sysguarder and delete the last entry
Started Windows normally and searched for sysguard and sysguarder
deleted everyting
I found (and deleted only c:\program files\sysguarder)
Performed a system wide virus check
Had fun with repairing my internet acess data!
A non-toxic way to control broad leaf weeds is to manually remove them and seed with grass. This will crowd out the weeds and prevent their re-growth.
Start>>Control Panel>>Add or Remove Programs. Find SP2 and click remove.
If you have Firefox, then you should go to your Add-ons options and disable the Neopets Toolbar. Or you can manually uninstall it in Control Panel > Add or Remove Programs.
hard work
Remove the radio/heater control module. Disconnect the temperature control cable at the base of the control assembly . It is on the center mound just to the right of the gas pedal. Take the heater control cable off of the back of the heater control module. Pull the temperature control cable off.
Remove the center console. The module will be in front of console under dash
Remove the center console and go in from the back and release the tab manually (screwdrvier)
To remove center air vent s a t20 tool is needed. Unscrew, climate control unit and compartment. After it is pulled away, their vents are exposed. To remove air vents unscrew bolts and pop out of place.
To effectively control and remove vine-like weeds in your lawn, you can manually pull them out, use a weed killer specifically designed for broadleaf weeds, or apply a thick layer of mulch to prevent their growth. Regular maintenance and monitoring of your lawn can help prevent the spread of these weeds.
remove the power chip or disconnect the battery and then disconnect it manually!!
You can't. It's a setting in the engine computer - remove that, and your motor won't operate.
You can't. It's a setting in the engine computer - remove that, and your motor won't operate.