0
Though there are many parts to an automotive engine taking one apart repairing it and putting it back together is possible. There are some special tools needed and also the specifications for each manufacturer, year, and size, of motor you are working on. For motors to operate correctly the clearances between moving parts must be with in tolerances. That said, the short answer is to reassemble the motor in the the reverse order that it was disassembled in. There are several subsystems that are removed as units. such as the electrical wiring harness, the air intake system, and the exhaust system/s, starter motors, charging systems, and ignition system. each one of these can be extremely complicated requiring many steps or very simple like unplugging a connector. after these systems are removed you are left with the block and head/s. Here again, even unbolting the head/s from the block, to prevent the head from warping, one must follow the pattern established in the engine specifications. While Only very old motors will have the valves mounted in the block so chances are the valves will come out with the head removal. It is usually more cost effective to send the head to a machine shop for service, with the valves intact They can be removed but it takes special tools. after the heads are removed the block with the oil pan, crankshaft, connecting rods, pistons, and oil pump, is the remainder. taking these apart is uncomplicated, but, putting them back together requires the specifications and special tools. With reassembly many times bolts and fasteners must be tightened in the proper sequence and to the correct tightness (torque). These can be found in a good shop manual.
What else can I help you with?
How do you disassemble and reassemble a Craftmans Eager 1 5.3HP Carburetor Model 917373680?
http://www.cpdonline.com/692509.pdf Engine Manual
Is it hard to change a head gasket?
Not if you know where everything goes on your engine. It's just really time consuming. If you know how to disassemble and reassemble your engine, go for it. Otherwise get a professional.
How do you disassemble and reassemble the extractor on a bryco mo 48 380?
You need a gunsmith.
How do you disassemble and reassemble a 916A Smith and Wesson shotgun?
Best left to a trained gunsmith.
How do you clean the carburetor on a Tecumseh ohv 6.5 hp engine?
Purchase a rebuild kit. Take the carb off the engine. Disassemble the carb. Clean the parts with carb cleaner. Reassemble and install then adjust carb (if applicable) while running the engine.
Where do you find a guide on how to disassemble and reassemble a bryco 38' 380 atuo pistol?
On line auctions.
How do you fix engine knock for Opel corsa classic 1.6 2005?
Assuming this is a bearing knock, remove the engine, disassemble engine, inspect, replace or rebuild worn parts (crankshaft, bearings, etc), reassemble engine, install engine. Or, you can go with a good used engine if you have a reputable salvage yard you can trust.
How do you disassemble and reassemble a 45 Tactical Automatic Smith and Wesson Pistol?
You can get manuals at the Smith and Wesson website.
How do you disassemble and reassemble an American arms 22 cal?
Best to ask a gunsmith for help if you don't have a manual
What rhymes with assembly?
I believe the word "dissembled" would rhyme. "Dissemble" means: "to put on a false appearance : conceal facts, intentions, or feelings under some pretense."
What are five ways to move a box from one room to another?
# Slide # Carry # Throw # Tumble # Disassemble, reassemble
What are the basic procedures in overhauling?
Disassemble, inspect, clean, replace/rebuild worn parts, reassemble to manufacturer's specifications.
