0
Since most flat slabs contain reinforcing steel, the minimum would be the thickness required to cover the steel, generally 2" top and bottom. But the real answer depends on what the slab is supporting and the level of safety required. For a very general situation where the slab is supported on all sides and not significantly longer in one direction, a slab can be 6" wide and support light loading if properly reinforced.
What else can I help you with?
What will be minimum covering for roof slab?
The minimum covering of reinforcement for roof slab is 30mm
Is rebate on pf inclusive in minimum slab of 160000?
No, the rebate on the provident fund (PF) is not included in the minimum slab of ₹160,000. The minimum slab typically refers to the income threshold for tax calculations, while rebates on contributions to PF are considered separately. Therefore, the rebate is an additional benefit that does not affect the minimum slab limit for taxation.
What purpose concealed beam used in slab design?
what pupose concealed beam use in slab design
What prefix is for flate?
"Flate" does not exist as a stand-alone word. If you meant "flate" as a misspelling of "flate," the prefix "in-" can be added to it to form "inflate."
Write about lighting at the ancient time?
flate
Slab bridge design?
Yes
What is the minimum thickness for flat slab?
The minimum thickness for a flat slab typically ranges from 4 to 6 inches (about 100 to 150 mm), depending on factors such as structural load, span length, and the type of concrete used. However, local building codes and design requirements may dictate specific minimum thicknesses. It's essential to consult structural engineering guidelines and regulations for precise specifications tailored to the project.
Minimum and maximum area of steel required in rcc slab as per BS code?
The minimum area of steel required in RCC slab as per BS code is 0.12 to 0.15% of total area. The maximum diameter of bar in slab, shall not exceed D/8, where D is the total thickness of slab.
What does the root word flat or flate mean?
The root word "flat" or "flate" generally refers to something that is level, smooth, or even. It can also describe something that lacks depth or dimensionality.
Design steps of two way concrete slab with an example?
i want desisgn steps of two way concrete slab with an example
How much Concrete do you need for a 22 squared slab?
A 22x22 foot slab at a 4-inch thickness/depth requires a minimum of 6 cubic yards.
Gas water heaters must be how high above the slab?
Minimum of 18" by Code.
