0
To check power to the distributor, first ensure the ignition is turned on, then use a multimeter to measure voltage at the distributor's power terminal. Connect the multimeter's positive lead to the terminal and the negative lead to a ground point. A reading of around 12 volts indicates that power is reaching the distributor. If there's no voltage, check the ignition coil, wiring, and fuses for issues.
What else can I help you with?
How do you test the ignition coil on a 1992 Acura Inetgra?
to check the ignition coil on the B18 you need to go to the little black box (distrubitor) where your spark plug wires are located and unscrew the 3 screws you will see. well first you need to disconnect the battery. then take a test light and see if it has power, and if not you need a new one. and if you need a new distrubitor, i have one...email, basketballpjb@aol.com
Your 86 ranger 2.9 qoil got power but no spark?
this means two things not enough power to give enough spark to the distrubitor cap meaning new coil requried or if u mean the spark plug wires or not giving spark replace all wires and rotor buton under the distrubitor cap ang clean the coil plug with a fine sand paper.
Replaced distrubitor on 95 cirrus car still wont start any suggestions?
Check the crank sensor. I had a 98 cirrus that wouldn't start and that was the problem
A distrubitor with vacuum advance compensates for varying altitudes?
engine load
Find you a mac tools distrubitor?
1-877-MAC-TOOLS
What is the firing order for 1998 Chrysler cirrus v6 with a distrubitor?
1,2,3,4,5,6
How do you time the distrubitor in a 94 Camaro lt1 engine?
You can spin it the has always work for me
Forgot to mark distrubitor on 350 when pulled how to get timing right now that its assembled?
pull the number one spark plug, turn the crank pully by hand till the piston hits top dead center,(to check for top dead center place a unsharped pencil in the spark plug hole as you turn the crank the pencil will rise and at the point it starts to go back down is top dead center) look at your rotor posistion, if not in the right place,(if you don't know which way the rotor should be pointing ask your parts man to show you in his book the distrubitor diagram) lift distrubitor off gear turn rotor till its just a hair past #1 posistion, as you lower the distrubitor the rotor will aline back in place, clamp it down, (hand tight to allow for adjustment) replace plug and wire, crank it over and then use a timing light to fine tune,once tuned tightin distrubitor clamp.if this is a carberated engine ask your parts man at what % to set the timing and also while setting it you will have to unplug the vacum advance hose to retard it.
Where can you buy domestic sandstone in large slabs possibly end cuts?
possability at a quarry, or look for a stone distrubitor,
Your 1996 gmc is sputtering just had a new distrubitor cap put on but not by dealer is that the problem?
It could be the firing order is wrong
On a 1974 Chevy 350 where is the 1 spark plug located on the distrubitor?
/ 7__2_ 5 / \1 [ ]> 6 \__/ 8 3 4
If you have no power windows power locks or power to the moonroof but all your fuses check good what else should you check?
check the circuit braeker
