0
An easy way to test them is to connect the pig tail to the positive terminal of a 12 volt battery and the body to the negative terminal. This charges them up. Now ground the pig tail to the body and, if it is good, you should see a nice fat spark. In some cases the condenser will have two leads. One goes to ground and one to the points hot wire. Connect them by the color coding of the wires. If both wires have the same color, they can be connected either way. Same way to test. One wire to positive and one wire to negative to charge and then touch them together. You should get a nice spark if they are good.
What else can I help you with?
Will a bad ignition condenser keep a motorcycle from firing?
Yes, a bad ignition condenser will keep a motorcycle from firing. A bad ignition condenser might also have caused the points to stick together and burn up.
Do you need a motorcycle to take the test?
No, you do not need a motorcycle to take the test.
Do you have to have a motorcycle to take the test to get a motorcycle license?
You can take the motorycycle test even if you don't have motorcycle yet.
Does the DMV provide a motorcycle for the test?
The Department of Motor Vehicles (DMV) typically does not provide a motorcycle for the motorcycle driving test. It is the responsibility of the test taker to bring their own motorcycle that meets the DMV's requirements for the test. The motorcycle must be in good working condition, properly registered, and insured. Additionally, the test taker must demonstrate proficiency in operating the motorcycle safely during the test.
Do you have to bring your own motorcycle for the test?
No, you do not need to bring your own motorcycle for the test. The testing facility will provide a motorcycle for you to use during the test.
Where can I take an official motorcycle drivers test?
you can take an official motorcycle drivers test at a residence that gives out the test or it could be possible that you could take an online official motorcycle drivers test.
Do you need a motorcycle licsense to test drive a motorcycle in Georgia?
if you need a license to ride a motorcycle in Georgia then you will need one to test drive one.
What are the requirements and procedures for taking the NC motorcycle skills test?
To take the NC motorcycle skills test, you must have a valid NC driver's license or learner's permit, pass the written knowledge test, and provide a motorcycle for the test. The test includes various maneuvers to demonstrate your ability to control a motorcycle. You can schedule the test at a DMV office and must pay a fee. Passing the test is required to obtain a motorcycle endorsement on your license.
How to test the pionts and condenser on a Ford truck?
Testing the condenser. (capacitor) Open the points and set the meter on ohms.
Do I need my own motorcycle to take the test?
No, you do not need your own motorcycle to take the test. Many testing centers provide motorcycles for the test.
What are the requirements and procedures for taking the motorcycle skills test in North Carolina (NC)?
To take the motorcycle skills test in North Carolina (NC), you must have a valid motorcycle learner's permit and provide your own motorcycle for the test. The test includes various maneuvers to demonstrate your ability to control the motorcycle safely. You can schedule the test at a nearby DMV office and must pass both the written and skills tests to obtain your motorcycle endorsement.
How do you test a auto ignition condenser?
To test an auto ignition condenser, first, disconnect it from the ignition system. Use a multimeter set to the capacitance setting to measure the condenser’s capacitance; it should be within the manufacturer’s specified range. If the reading is significantly lower or shows an open circuit, the condenser is likely defective. Additionally, you can perform a basic test by checking for continuity; a good condenser should show no continuity when tested with a multimeter in the resistance setting.
