answersLogoWhite

0

In New York State, the minimum thickness for rear brake shoes during an inspection is typically 1/8 inch (or approximately 3.2 mm). If the brake shoes are worn down to this thickness or less, they must be replaced to pass the inspection. Additionally, inspectors may also consider the overall condition of the braking system, including any signs of damage or uneven wear.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

What is the Minimum thickness of brake shoes for 2002 ford focus lx?

The minimum thickness of brake shoes on a 2002 Ford Focus LX is 0.32 inches. Whey they fall below this thickness, they lose much of their stopping power.


What is the minimum thickness for 2005 Ford Escape rear brake shoe?

The minimum thickness for rear brake shoes on a 2005 Ford Escape is typically around 1/16 of an inch (approximately 1.5 mm). It's important to regularly check the brake shoes for wear and replace them if they are at or below this thickness to ensure optimal braking performance and safety. Always refer to the vehicle’s service manual for specific recommendations and guidelines.


Minimum thickness on brake shoes?

Depends on which vehicle. Most regular cars around 10mm. when new. Max wear is down to 2 mm. Any vehicle.


What is the minimum thickness for kenworth brake shoes?

The make and model of truck doesn't matter.. FMCSA dictates that it cannot be less than 3/16" thick at the center for shoes with a continuous lining, and 1/4" inch at the center for systems which use two separate shoes.


How do you adjust parking brake on a Chevy s-10 2003?

Start with an inspection and adjustment of the parking brake shoes by removing the rear brake rotors. If the brake shoes are good and they are adjusted up and you still need more adjustment, make final adjustments on the brake cables under the drivers side of the vehicle.


What items should be checked while carrying out a brake inspection?

break lining break pads break shoes break pipes break fluid leakes brake disk


How do you know brakes are bad on air brake?

If the brake shoes measure less than 4/32nds thickness, if cracking or warping is observed on the brake drums, if the brake shoes and/or drums become coated in oil (as is what happens when a wheel seal goes bad), or if you hear escaping from the brake chambers when the brakes are released, then you know at least one component in the brake system is bad.


What is the minimum rear brake shoe thickness for a Honda?

Guideline when replacing Honda Rear Drum Shoes over 2mm or 3/32": okay at 1.01mm to 2mm or 2/32" to 3/32": you might considering replacing very soon at 1mm or 2/32" or less: get those rear drum shoes replaced immediately!


Hello I have a 1999 Mercury Sable I took it for inspection and was rejected The mechanic said I needed both front brake pads and both rear brake shoes also a master cylinder Could you give me an e?

Hello. I have a 1999 Mercury Sable. I took it for inspection and was rejected. The mechanic said I needed both front brake pads and both rear brake shoes also a master cylinder. Could you give me an estimate on the labor for all of this. I already bought the parts. Thanks


How do you change rear brake shoes a lancer?

Remove the tire and wheel from your Mitsubishi. Remove the brake spring and the brake caliper. The brake shoes will come off. Reverse the process to install your new brake shoes.


What is the least amount of brake lining that you have?

Depends on what type of brakes you have. On medium- and heavy duty commercial trucks with S-cam foundation brakes, you must have at least 4/32nds of thickness on two piece brake shoes at the center.


How do you fit rear brake shoes to a 1996 frontera 2.8 tdi?

The simplest way to fit rear brake shoes to your 1996 vehicle is to purchase the appropriate brake shoes. The appropriate brake shoes will automatically fit perfectly.