slide your finger nail around the edge of the back and it will pop right off. I just did it an there is a white cap over it lift it out an thiers the battery
To remove the back of a pocket watch, you typically need a case wrench or a watchmaker's knife to pry it open. Be careful not to damage the watch case or the movement inside when attempting to remove the back. If you are unsure, it is best to seek the help of a professional watchmaker.
the back of the watch case comes off but stem recesses into watch works preventing removal of watch works unless stem can be removed
As far as pocket watches go, there should be a small knob at the top of the watch, if you twist it it will wind the watch, if you pull it out and twist you can use it to set the clock. But, that is going by a general pocket watch design.
You can send it back to Colibri and have it repaired for $7.50. You might be better off looking at a new Xikar ...
Pop off the back of the pocket watch. I use a sewing pin to achieve this. You will see a circular plastic part with a different shape in the middle that is on top of the battery and keeps the watch face in place. Mine is colored white. Pop that off from the bottom. From there press up underneath the battery. There should be a little groove underneath where the battery is. After that inspect the battery that was already in there. For example: Mine was a V377+ Varta Germany. I bought a Energizer V377 and put it in. It works like a charm. Put the plastic part back on top of the battery. Then pull up on the top of the pocket watch, moving the spinning part of the watch. Carefully put the back of the watch back on, as jiggling it a little will change the time you've so specifically changed. After the back is on, then push down on the top of the pocket watch. This will start the second counter again. Tada. You have changed the battery of a ciprini pocket watch.
Milan quartz Japan movt, pry off back cover, (info written on back cover); MLN838, 138, PC32, Battery 377. remove plastic spacer/battery retainer by lifting out,, replace battery with +/positive side facing out/toward back of watch. info on actual battery ; SR626SW SEIZAIKEN JAPAN
Place the watch face down in the palm of your left hand. Place the palm of your right hand on back of the watch. Push palms together and turn right hand counter-clockwise. Clock back should screw off. I have one watch like that, but this watch has hinges. I can get the first part open, but not the next layer to view the movement. Thanks for trying to help!
i dont know but when you sit down on a hard chair it will crack your screen if its in your back pocket.
In order to take a back off of a Kahuna watch, you must use a small Phillip's screwdriver and remove the tiny screws keeping the back in place. Once you have accomplished that, the back should easily slide off.
mine is a spin off back had to use needle nose pliers and spin the back on and off using the tips of pliers and the notches in the back
If you cannot get the back of your watch back on, to prevent any destruction or further damage, you should take the watch to a professional. anonymous@oola.com