Washing machines have lid locks primarily for safety reasons. The locks prevent users from opening the lid while the machine is in operation, reducing the risk of injury from moving parts and water splashes. Additionally, lid locks help ensure proper washing performance by preventing interruptions during cycles, which could lead to unsatisfactory cleaning results.
1920's washing machines didn't have a lid. You would have to get the hose from the garden and fill the washer machine up!
If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.
The wig-wag or spin actuator or belt is faulty. -Simple problem for someone experienced in washing machines.
Could be lots of reasons. Most washing machines have a small pin on the lid usually opposite the hinges that pushes down on a switch when the lid is closed. Sometimes this pin breaks or comes out. This is a safety feature so that someone doesn't get caught in the wringer.
a screwdriver opening a the lid of a paint can
A faucet handle and jar lid are simple machines.
My door locks stopped working and I pulled the IOD fuse and reset it back after starting the vehicle. Now all locks work great to include the remote process. The IOD is mapped on the lid of the fuse box.
The pump may be bad or weak. You can check the small lid switch under the lid. When you close the lid...it will engage. These will sometimes get out of sinc with the lid and not engage.
If your washing machine will agitate, but refuses to spin out, you more than likely have a bad lid switch. A lid switch, when working properly, tells the washing machine when the lid is closed, thus allowing the washer to spin out. A faulty switch will signal that the lid is still open, even though it isn't, and the water will not spin out. Repairing a lid switch is easy for the average do-it-yourself person with some instructions from internet sources, especially videos. These switches will run anywhere from $20-$60 depending on the machine and are found at your local appliance repair centers.
There should be a tag under the lid on the rim of the opening.
If your washer cycles but won't spin, first check for an unbalanced load or clogged drain filter/hose. Ensure the lid switch is fully engaged. If these aren't the issue, the drive belt or motor coupler might be faulty.
It sounds like a lid switch to me. i just don't know what a Kirkland signature machine is like, but all machines have some kind of switch to make it turn on And when they go out your machine will not drain. Go to Youtube and see if they have that type and they will show you how to fix it step by step. It's free