answersLogoWhite

0

Side to side leveling, measure blade tip at its outermost point to the ground on both right and left side (level surface). Turn right lift link in or out to adjust...1 full turn equals 1/8 inch. Difference side to side should not be more than 1/8 inch. Front to rear leveling, Turn right blade to front/rear position, measure front to ground then turn blade 180 degrees and measure rear to ground. Rear should be 1/8 inch more than front. Adjustment is by turning the yokes on the front of the deck (below draft arm connection) after removing draft arms. Again one full turn equals 1/8 inch. To adjust cutting height, With the mower lifted as high as possible, there is a T shaped screw at the left rear of the tractor which controls the height. Turn this stop counterclockwise as far as possible then lower the deck to the desired cutting height, stop engine and turn the screw clockwise until it stops. Now the cutting height is set.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where can you find the serial number for a John Deere L130 mower deck?

on the mower deck


How do you change a mower deck belt on a John Deere L130?

How do you change a mower deck belt on a John Deere L130?Read more: How_do_you_change_a_mower_deck_belt_on_a_John_Deere_L130


Do you have a picture of routing a drive belt on a mower deck?

john deere LT155 38inch cut mower deck


What size mower deck goes on a john deere 111?

38'' deck


How do you replace deck on lx255 john deere mower?

anonymously


How does one adjust the tension of the mower drive belt on a john deere 260 with a 46-inch deck?

Its all spring loaded. No adjustments needed.


How do you install the mower deck on a LT133 tractor?

The deck must be slipped beneath the machine from the left, the lift lever locked down and the rear hangers and front hanger plate attached. The belt will take take a 90 degree twist with the front part to the left side.


Does a F725 John Deere Front Deck Mower have a thermostat?

Yes


Mower deck route for john deere L120?

need a diagram for the belt on my L120 lawn mower


Will the deck on a john deere f910 fit the f935 mower?

Yes it will fit.


What is the belt pattern for John Deere 48 mower deck?

The John Deere 48 mower deck belt pattern diagram can be obtained from most John Deere dealerships. Many times when you purchase the belt the parts store will give you a belt pattern diagram.


How do you change a John deere la 175 mower deck belt configuration.is there a diagram?

You can change a John Deere LA 175 mower deck belt configuration by checking the diagrams and instructions in the owner's or manufacturer's manual basically.