It unscrews. I thought it was pressed on, but apparently not. I found this out after I had a puller on it and heated thinking it was froze well it came apart but only because the spider is aluminum and the shaft is steel. It sheared the threads off of the spider. But now you know it is screwed on.
remove deck...remove pto clutch and both idler pulleys and u should be able to put on
a john deere 630 is a two cylinder tractor that has a hand clutch two wheel drive
I changed the drive belt and idler pully,now only one back wheel works.how do I fix it
Try the link attached. Note: clutch does not have to be removed, just makes it a bit easier. Idler next to the clutch must be centered on slot usually.
remove clutch cover. remove old belt. install new belt.
To install drive belt on a 1999 Kawasaki Prairie 400 4x4, access the engine area and remove the cover that holds the clutch. Remove the drive belt around the clutch at the right side of the engine. Replace with new.
To change the clutch on a Volvo 760, first, disconnect the battery and remove the transmission by unbolting it from the engine and separating it from the drive shaft. Next, remove the clutch cover and disc from the flywheel, ensuring to note the orientation. Install the new clutch disc and cover, aligning them properly, then reattach the transmission. Finally, reconnect the battery and test the clutch operation before taking the vehicle for a drive.
1. Buy a New clutch and pressure plate 2. Remove gearbox 3. remove old clutch and pressure plate 4. fit new clutch and pressure plate 5. fit gearbox 6. Drive
Remove fan clutch with fan impeller. Remove A/C compressor drive belt. Remove cap from tensioning roller. Relieve tension on drive belt. Remove drive belt. Reverse procedure for installation.
How Do I change A drive belt on a John Deere LT190?
John Deere: Drive Green Game
Remove airbox, drive shafts, all connectors onto gearbox, gear selector rod, battery and battery tray, starter motor and then all bolts securing the gearbox. Remove gearbos, and then remove the bolts securing the clutch. Fit new clutch making sure you allign the clutch plate. Refit everything in reverse.