0
I would think you arereferring to the drive belt. First thing to do is remove the mowing deck. From there you will find a spring lever that holds the belt tight. You will need to take a bar or wrench and release the tension on the belt and take the belt off of that pulley. Then from there it is a matter of loosening the pulley next to the frame and snaking the belt from around all the other pulleys in order to get it off. To install just do everything in reverse. In order to gain access to every thing it is best to stand the mower up on the rear wheels, you will need someone to hold the tractor in this position while you remove and install the drive belt. Just recently done this and the job is not really to hard. Just take your time as to not remove unnecessary components. You will have to loosen some of the pulleys but none have to be removed as I remember.
What else can I help you with?
What is the value of your 2004 John Deere LT133?
they only made the LT133 from 1998-2001
What starter fits a john deere lt133 mower?
The correct one.
Spark plug gap John Deere LT133?
.040 thousandths
How do you remove seat lt133 John Deere?
how do I remove the seat bracket from a lt133 john deere mower
How do you drain oil on john deere lt133 13 horsepower mower?
pull the plug
What size battery for a John Deere lawn tractor LT133?
12 volts / 160 cold cranking amps
How do you know if your coil is bad on john deere lawn mower?
Lt133 lawn tractor will not fire is coil bad
How do you install the mower deck on a LT133 tractor?
The deck must be slipped beneath the machine from the left, the lift lever locked down and the rear hangers and front hanger plate attached. The belt will take take a 90 degree twist with the front part to the left side.
How do you tighting a John Deere LT133 transmission belt?
To tighten the transmission belt on a John Deere LT133, first, ensure the mower is on a flat surface and the engine is off. Remove the cover to access the belt, then adjust the tension by moving the idler pulley or adjusting the belt guide, ensuring the belt has the correct amount of slack. Once adjusted, recheck the tension by manually rotating the belt, then reattach the cover securely. Always consult the owner's manual for specific instructions and diagrams related to your model.
Is the John Deere 8345r a manual transmission?
The John Deere 8345r has an ivt transmission.
How do you replace starter solenoid on LT133?
To replace the starter solenoid on a John Deere LT133, first disconnect the battery to ensure safety. Remove the old solenoid by disconnecting the wiring and unscrewing it from the frame. Install the new solenoid by securing it in place and reconnecting the wiring according to the original configuration. Finally, reconnect the battery and test to ensure the starter functions properly.
How do you replace the battery on a John Deere 445?
how to replace battery in z425 zero turn john deere mower
