The half-hour bell on your Seth Thomas adamantine clock might not chime due to several reasons: the clock mechanism could be jammed, the chiming mechanism may be disengaged, or there could be a mechanical issue such as a worn gear or broken spring. Additionally, it’s possible that the clock needs winding if it's a mechanical model. Regular maintenance and cleaning can help ensure proper functioning of the chiming mechanism.
What ever someone is willing to pay for it
I have a Walthram 31 day chime clock and on of the weights fell to the bottom of the clock. How do I fix it and why did it fall?
4 seconds
$150.00
To reset a clock that chimes 2 minutes before the hour, first, locate the time setting mechanism, usually a knob or a dial. Turn the knob to set the clock to the correct time, ensuring you move it forward past the chime point to avoid confusion. If the clock has a chime setting feature, check the manual for instructions to adjust the chime mechanism accordingly. Finally, observe the clock to confirm it chimes at the correct hour.
What ever someone is willing to pay for it
Check the back for kinks
Seth Thomas made many varieties of Sonora chime clocks. Some had 4, 5 or 8 cupped bells and some had chime rods. Value depends upon configuration and condition. A range would be between $150.00 and $3000.00
Just bought a used Daniel Dakota Westminister wall clock and it does not chime.
To calibrate the Daniel Dakota Westminster Chime clock, first wind the clock fully. Then adjust the time to 5 minutes before the desired time and let the clock chime. You can fine-tune the clock by adjusting the minute hand to the exact time when the chime sequence ends. Repeat as needed until the chime matches the correct time.
I have a Walthram 31 day chime clock and on of the weights fell to the bottom of the clock. How do I fix it and why did it fall?
It depends on the clock; None of my clocks chime even once. A clock that rings the quarter hours (like the clock in the Palace of Westminster - aka, Big Ben) would chime 96 times per 24 hours. Some clocks only chime on the hours, which would be 24 chimes/day.
4 seconds
You cannot turn off the chimes on this clock
To correct the hour discrepancy on your mantel clock, first, ensure that the clock is set to the correct time. If it chimes an hour early or late, you may need to adjust the chime mechanism. This is typically done by locating the chime adjustment lever or screw, often found on the back or side of the clock, and carefully turning it until the chime aligns with the correct hour. Finally, check the clock again after a full hour to ensure the chimes are synchronized with the correct time.
To repair a Trend Chime Clock, first, carefully open the clock casing to access the movement mechanism. Inspect for any visible issues, such as loose gears or broken parts, and ensure the clock is clean and free of dust. If necessary, lubricate the movement with clock oil and replace any damaged components. After making repairs, reassemble the clock, set the time, and test the chime function to ensure proper operation.
The Seiko QXH-series can chime on the hour, but you'll have to enable it first.