0
How can you get the pilot light on a teledyne pool heater to start if you have pressed pilot and the red button?
Wiki User
∙ 14y ago
sit on it then throw it into a creepy cave
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How does a light sensor work?
A light sensor shines a light on the image to be scanned and collects the data as simple changes between black and white based on the level of reflection. These changes are later converted into digital form for processing.
What are the advantages and disadvantages of using diesel?
pros: burns clean and heats evenly. If the electricity goes out, you can still heat with gas. Compared to an electric heater attached to a gas-burning electric power station, a natural gas heater uses less fuel and puts less CO2 in the air. cons: cost a fortune now a days. +++ There is a proviso there. A power-cut will prevent most gas-fired central-heating boilers to cut out, or not light at all, by denying electricity to their internal fans and control electronics; and of course the the circulating pumps would stop too.
What describes a material's ability to reflect light or shine?
The material's Luster (lustrous would mean it reflects light) (dull is the opposite)
Materials which transmit no light are referred to as?
Materials which do not allow the transmission of light are called opaque. These substances have chemical compositions, some of which are referred to as absorption centers. This means that the material absorbs all of the light wave frequencies, not just some while reflecting other frequencies.
Which travel faster than light or sound waves?
Which of them travel faster - light or sound waves? Light waves travel in vacuum with the speed of light c = 299792458 m/s or 983571056 ft/s. Sound waves travel at 20°C (68°F) with the speed of sound c = 343 m/s or 1125.33 ft/s. So light travels 874,030 times faster than sound. Don't forget that sound needs necessarily air as a medium. Light does not need a medium; vacuum is O
How do you light the pilot on a 10 year old Teledyne Lars LLG pool heater with an electronic spark?
You don't. If the heater has an electronic spark, then it doesn't have a standing pilot to light. The spark lights the pilot when there is a call for heat, which in turn lights the burners. If the heater is on and the pump is RUNNING, the heater should light automatically when the water temperature is lower than the heat setting.
Is there a common cause for a 1987 454 ltd not to crank when the start button in pressed?
Start by checking battery voltage and then use a test light to check for power at the starter when the button is pressed. If you have power at the starter with the button pressed it could be a bad starter. If no power at the starter then check into wiring and/or relays.
How can you reset the Citroen C5 service light?
Press in and hold the trip reset button. Switch on the ignition keeping the button pressed.
How do you light jvt-50c teledyne laars gas heater?
Lighting this heater appears to have a number of warning messages associated with it. It is typically best to go to the source for such things, so see the link below for the manual PDF file. Look at page 29.
Is the pilot light bad when it produces 200mv at the maximum temperature setting but won't start the burners on a Teledyne pool heater?
I was told by Teledyne Laars that your pilot generator needs to produce at least 500mv to open the gas valve. Mine makes 350mv and will not open the valve. Hmm, I think that should be nearer to 600 mv - 700 mv.
What is latch output?
It's an output that is set to on by a momentary input. i.e. a pushbutton turns on a light and the light stays on even when the button is not pressed. The output is 'latched'.
What does the power warning light mean on a 1999 Chevy Tracker?
It is not a "warning" light but an indicator that you have pressed the button near the shifter to put the tranny into tow mode.
How does film record its images?
There is a coating on the film that is sensitive to light. When the camera button is pressed, the shutter opens, allowing light from the subject to fall on the film's surface. this creates the image.
Why would a Teledyne Laars heater thermostat allow you to light pilot light but not allow you to turn it on?
Have you rotated the gas valve knob to "run". Have you turned up the thermostat? Is the pump running? No pump water flow - no heat -- no filtration. Is the filter clean? When was the last time you cleaned the filter? Ken
How do you reset the engine management light citroen picasso?
To reset the engine management light on a Citroen Picasso, press and hold the trip reset button. Turn ignition key to position 2. By keeping the button pressed in, the trip meter will count down. When zero is reached, release the trip button and the start car service light will be extinguished.
How do you turn reset oil change light on Honda ps125?
1. Set the ignition key to off.2. Press the clock button and keep it pressed while turning the ignition switch to on.3. Keep it pressed untill the oil change light goes out (about 2 seconds)
How do you reset the Maintenance Required light on a 2002 Honda Civic EX?
Press and Hold the reset button located at the odometer. 2. Turn the ignition key to ON only, keep the reset button pressed until the maintenance light goes off (about 10 seconds).
