answersLogoWhite

0

Motors in heaters are to run the fans to distribute the heat over a larger area.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the temperature limit to use motor pre heater?

+5


Where is the heater resister motor located?

plastic cover for heater motor


How do you replace the heater fan motor on a vauxhall vector life?

Remove the wiring harness from the back of your heater fan motor. Remove the heater fan motor retaining bolts. Remove the fan from the front of the heater motor. Reverse the process to install your new heater motor.


Where is the heater motor resistor on a 2009 vauxhull astra?

Heater motor speed resisters are usually located close or nearby the heater motor.


How do you change heater fan motor 94 Chevy 3500?

Remove the wiring harness from the back of your 1994 Chevy heater fan motor. Remove the heater fan motor retaining bolts. Remove the fan from the front of the heater motor. Reverse the process to install the new heater fan motor.


Blowers not working on Renault scenic?

broken heater motor but where is heater motor inside from?


How do you fit lada niva heater motor?

Remove the center switch console. remove the 4 spring clips holding the square heater motor housing and remove the housing. Inside the heater motor housing Remove the two spring clips holding the heater motor in Remove wiring connections and then remove the heater motor. Install new heater motor and installation is in the reverse order of above.


How do you change the heater motor for 1998 Chevy Lumina LTZ 3800?

Remove the wiring harness from the back of your 1998 Chevy Lumina heater motor. Remove the heater motor retaining bolts. Remove the fan from the front of the heater motor. Reverse the process to install the new heater.


How do you remove heater motor?

first remove the window wiper arms then remove the plastic trim this will reveal the heater motor, then unclip the electrics and the unbolt the motor (on some cars you have to remove the wiper motor to take out the heater motor)


How do you test heater motor peugeot 406?

To test the heater motor in a Peugeot 406, start by checking the fuse associated with the heater system to ensure it's not blown. Next, disconnect the motor's electrical connector and use a multimeter to measure the voltage at the connector while the heater is turned on; there should be a voltage reading if the circuit is functioning correctly. If the voltage is present but the motor does not run, the motor likely needs to be replaced. If there is no voltage, further investigation into the switch or wiring may be necessary.


How do you wire a 12 volt heater motor in place of 2 wire 6 volt heater motor?

To wire a 12-volt heater motor in place of a 2-wire 6-volt heater motor, first ensure that your power source can supply 12 volts. Connect the positive wire from the 12-volt heater motor to the positive terminal of the power supply, and connect the negative wire to the negative terminal. Make sure to use appropriate fuses or circuit breakers to protect the system from overcurrent. Lastly, confirm that the motor's specifications are compatible with your application to avoid damage.


Heater motor only works on high 2002 dodge caravan 95000miles?

Replace heater motor resistor.