0
What else can I help you with?
How do you change a 2000 Chevy 3500?
You did not SAY what you were CHANGING. NEUTS
How many quarts does a 2007 Chevy Malibu 3500 V6 use?
A 2007 Chevy Malibu 3500 V6 uses 5 quarts of motor oil. It uses standard 5w-20 motor oil for a good balance of performance and protection.
Where is vthe high speed blower motor relay on a 2001 Chevy 3500?
Its located in the center of the dash behind the dash panel mounted on the a/c heater housing and if you remove the glove box and look to the left you will be able to see it.......
Can you change your 1991 Chevy 3500 4x4 to manual hubs?
no it cannot be done
What is the gas mileage of a 1989 Chevy silverado 3500 with a 454 motor?
1989 k 3500 only gets 5 miles to the gallon,and my k 3500 is running rich and i am really trying to find out.
How do you replace an upper control arm bushing on a 1998 Chevy express 3500 van?
puting your finger in the motor
What is the GVW of a Chevy 3500 Truck?
what is the gvw of a 1993 chevy 3500 vin#1gchk34f5pe176469
Where is the blower motor located on a 95 dodge ram van 3500?
It is located in the engine compartment passengers side on the black heater box
Will a 1993 Chevy 3500 truck bed fit a 1991 Chevy 3500?
YES, They are the same.
Where is the blower motor located in your 99 Chevy k 3500?
On the passengers side under the glovebox near the side kick panel.........
How do you replace heater core on a 2000 3500 Chevy Express van?
To replace the heater core on a 2000 Chevy Express 3500 van, start by disconnecting the negative battery cable and draining the coolant from the radiator. Remove the dashboard and the HVAC housing to access the heater core; this typically involves removing several screws and connectors. Once exposed, disconnect the heater core hoses and remove the old core, then install the new one in reverse order. Finally, reassemble the dashboard, refill the coolant, and check for leaks.
How do you replace wiper motor on a Chevy 3500?
To replace the wiper motor on a Chevy 3500, first, disconnect the vehicle's battery to ensure safety. Remove the wiper arms by unscrewing the nuts at their bases and gently pulling them off. Next, take out the screws securing the wiper motor cover and disconnect the electrical connector from the motor. Finally, unbolt the motor from its mounting and replace it with the new unit, reassemble in reverse order, and test the wipers before securing everything back in place.
