main two type of bearing used in steam turbine:(1)thrust bearing (2)general bearing
Rankine cycle is used in steam turbine
Steam turbine is when a device that has the extract thermal energy from pressurized steam. It is used to do mechanical work on a rotating output shaft. The steam turbine was invented by Sir Charles Parsons in 1884.
STEAM TURBINE is a machine for generating mechanical power in rotary motion from the energy of steam at temperature and pressure above that of an available sink. A turbine operated by highly pressurized steam directed against vanes on a rotor.HEAT ENGINE is a physical or theoretical device that converts thermal anergy to mechnical out put.....it converts heat energy into work.
he use bronze he use wood.
it is used balance axial thrust on turbine rotor due to admitting of high pressure steam in to turbine. it basic purpose is to save thrust bearing.
The types of values used in steam turbine range from 10 to 30 deg.of which 12 to 20 deg. are more common.
Rankine cycle is used in steam turbine
Depends on how you want to catigorize them ... mobile or stationary piston or turbine condensing or non-condensing and weither the power comes from the steam pressure or from the vacumm you get when you condence the steam.
Steam turbine is when a device that has the extract thermal energy from pressurized steam. It is used to do mechanical work on a rotating output shaft. The steam turbine was invented by Sir Charles Parsons in 1884.
Steam engines presently produce more power than all other types of engines combined. Most steam engines take the form of the steam turbine engine. The steam turbine is responsible for generating about 86% of the electric power used on this planet. Reciprocating steam engines are still in use for limited applications, but are generally considered obsolete. Steam engines, either the piston or turbine type were used on most big ships until recently, and there are still a few steam locomotives about.
A turbine.
In a back pressure turbine all available energy from the inlet steam is NOT used to generate power; steam exhausts at a tangible pressure and is then used for, usually, heating or chemical processing. In a condensing turbine, all the inlet steam does mechanical work right down to the lowest pressureafter which it is condensed in a heat exchanger
There is a type of electrical generating machine called a steam turbine. Steam is used to make the turbine spin. The turbine contains magnets, and the moving magnetic fields, as they intersect wires, generate electricity.
Membrane-type flexible coupling is used in steam turbines.
A kenotometer is an instrument used in steam turbine condensers to measure the vacuum in the steam space of the condenser. The vacuum achieved by the condenser has significant influence on the efficiency of the steam turbine.
Coal is burned to make heat, and the heat is used to boil water, which produces steam, and the steam pressure is used to rotate a steam turbine, and the rotating turbine is used to generate electricity.
Steam (under pressure) comes into contact with the blades of the turbine through which it is flowing and, by the direct application of force, causes the blades to move, turning the turbine shaft. The turbine coverts the thermal energy of the steam into (rotating) mechanical energy. Surf on over to our friends at Wikipedia using the provided link and get more info. Oh, and check out the pics! Answer it depends what type of turbine one is using types of steam turbine 1 impulse turbine 2 reaction turbine in 1 st one steam is completely expanded inside nozzle and all pressure energy get converted in to kinetic energy using this impulse force turbine runs. in 2nd steam is multiple stage blades are used where high pressure superheated steam gets expanded inside the turbine in each stage and after each stage velocity of steam increases. very high temperature superheated steam is reaquired because it has very high specific volume which helps in reducing mass flow rate of steam.