A center crankshaft has the crank located?æin the middle. An overhung crankshaft, also known as a side crankshaft, has it located to the side.
what is difference between lateral and longitudinal?
What is the Difference between technology innovation
What the difference between process piping and power piping?
There is no difference between a turning machine and a lathe. They are two names for the same kind of machine
=== ===
I would say that they are one and the same.
The tone wheel for the crankshaft position sensor is different.
its behind the timing cover and reads a plate between two crankshaft sprockets
The crankshaft position sensor is on the same side of the engine as the alternator and dip stick. It is about halfway between front and back, in the side of the block.
The Crankshaft sensor and the Cam sensor monitor the position and or the speed of rotation of the crankshaft. Together they send signals to the ECM. The ECM uses that information along with info from other sensors to send spark and fuel to the cylinders at the correct time. Some engines only have only a crank sensor to perform that job. Other engines that have both crank and cam sensors that split the duties.
by what i understand its located between the crank pully and block.
The Crankshaft Position Sensor is located on the drivers side between the motor and the firewall. If it is faulty you may notice your car will not start, will turn off unexpectedly or will perform intermittently. I have provided a link to me replacing the Crankshaft position Sensor (CPS) on my 2000 Mercedes Benz S500. http://youtu.be/KTTM3VeJuA8
the crankshaft position sensor is located between the main pulley and oil pump pulley in the lower part of the timing belt.
The initial position is where an object starts from, while the final position is where it ends up after moving. The difference between the two positions gives the distance traveled by the object.
It is located between the distributor at the back or the engine.
There is no difference between the Dodge and Plymouth engines.
None. It is the stroke of the crankshaft. They both have 4 inch pistons.