It is the octane number range the distributor automatic spark advance can handle without the engine knocking.
I am look for a engine for a infinti qx4 i need to see were a knock sensor goes am trying to fix it
An 800cc engine has a size of 800 cubic centimeters. This kind of engine would likely be found on a motorcycle or four wheeler.
Diesel knock is generated due to fully advanced timing and retard conditions. If the timing is retard the fuel will not be burned purely and rapid pressure will be developed and pinking noise will be generated. In a advance condition the fuel is injected in to the combusion chamber before reaching the piston tdc the burning will start suddenly otherhand the piston is being compresses the charge. The combusion should be done at maximum pressure and temperature but in this case the fuel does not burnt at that stage (actually piston wants the load at that time)the pressure is not developing instanteniously rapid pressure developed thats why the diesel knock generates. Another reason for diesel knock if diesel does not have the good cetane number knocking will be generatedTHIS ANSWER HAS SUBMITTED BY LOHITHKUMAR S FROM TATA MOT0RS MANGALORE
A gas turbine engine will usually yield more power by weight than a piston engine. Main downside is that it can't be throttled very well. Energy efficiency isn't all that good to start with, and will drop right down if it has to be operated outside its optimum range.
A suitable replacement engine for a Tecumseh HH60 is typically a small engine in the 5-6 horsepower range, such as those from brands like Briggs & Stratton or Honda. Ensure the replacement engine has similar mounting dimensions and shaft specifications to fit your application. It's also important to consider the compatibility of the engine’s output shaft with the equipment’s drive system. Always consult with a small engine specialist or reference the equipment’s manual for specific recommendations.
The knock sensor just advances and retards the engine timing only. If there is a noise in the engine then you have engine are valve train problems. The knock sensor will not make the engine knock.
This is controlled by a knock sensor.
I have a recent engine knock on my 91 escort started out intermittant. I have a recent engine knock on my 91 escort started out intermittant.
knocking as in spark knock? or engine knock? spark knock is adjusted through a knock sensor via ignition timing. eng. knock is due to brg. knock as in low oil pressure or sluge in engine or just a tired motor
NO it will not. If you have a knocking sound then you have trouble inside of the engine.
No. It only senses engine vibration/knock.
Severe spark knock (pinging) can damage the engine. Knock sensors detect spark knock (pinging) in the engine. They send that info to the ECM (Engine Control Module). The ECM makes temporary adjustments in engine timing to eliminate the spark knock.
A bad knock sensor would illuminate the check engine light and allow the engine to ping (spark knock). The engine doesn't shift, the transmission shifts.
And engine knock is normally caused but I worn crankshaft bearing or rod bearing.
If the knock sensor failed the CEL (Check Engine Light) would be illuminated and the engine may "ping" or "spark knock" under load. Serious "spark knock" can damage the engine if allowed to continue.
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
Yes it can hurt your engine to drive with a bad knock sensor. The knock sensor should be replaced as soon as possible.