The brake horsepower varies as a cube of the impeller diameter.
The Impeller is the rotor blade attached to the motor that creates the suction. It's different than a normal blade because the fins are between two flat round disk layers(usually aluminum on a shop-vac)
The only one difference in b/w compressor and pump rotor is impeller shroud width.Fluid is incompressible so impeller shroud width is not change and gas is compressible so impellers are tends to thin in width to the discharge side.
voloute convord the pressure into volicity and the mixtur of propallere and impeller is called turbine pump
the minor diameter should be between 4.917mm and 5.153 mm, so the largest allowable size is 5.153mm
Labrynth seal clearances depend up the diameter of the rotating shaft, bearing clearance & temperature of the lubricating medium. As ageneral thumb rule the clearance must be 0.03 mm per 1" dia of shaft.
The relationship between the radius and the diameter of a circle is that: radius = diameter /2
There is no direct relationship between a cc and horsepower. 10
1hp=746watts
The radius is half the diameter of a circle.
The circumference is pi times the diameter.
There is no direct relationship between horsepower and speed
In a pipe system, there is an inverse relationship between pressure and diameter. This means that as the diameter of the pipe increases, the pressure within the pipe decreases, and vice versa.
The radius is excatly half of the diameter
circumference = pi*diameter or pi = circumference/diameter
Circumference = diameter x pi
No, there is not.
Yes because: circumference/diameter = pi and circumference = pi*diameter