answersLogoWhite

0

What else can I help you with?

Related Questions

What is static load on machine tools?

Static loads on machine tools refer to the forces and pressures exerted on the machine when it is not in motion or when a tool is not cutting. These loads can come from the weight of the workpiece, clamping devices, and fixtures, and they must be considered when designing and operating machine tools to prevent deformation or failure. Calculating and managing static loads is important for ensuring the accuracy and longevity of the machine.


Cutting tools and machine tools is the same?

No. Machine tools use cutting tools to perform its operations.


What are automated machine tools known as?

Automated machine tools are more commonly known as numerically controlled (NC) machine tools.


What are the machine invented before the computer?

pascaline & difference engine cotton gin & stone tools


When was Hindustan Machine Tools created?

Hindustan Machine Tools was created in 1953.


Who did The Egyptians learned about making bronze tools and using chariots from?

The Egyptians learned about making bronze tools and using chariots from the Hyksos.


What is Bangladesh Machine Tools Factory's population?

Bangladesh Machine Tools Factory's population is 515.


What is the advantage of having custom machine tools ,over the standard machine tools available of the self?

Custom machine tools are made to your specifications. Standard tools you are stuck with what they design. Custom machine tools are the most suitable for meeting all your requirements but it comes with cost. In many cases the standard tools will serve all the purposes.


Where can you purchase machine tools online?

You can purchase machine tools online at machinetoolsonline, also locatoronline and mmsonline there is also an auction site where you can buy slightly used machine tools at auctionmachinetoo.


When was Bangladesh Machine Tools Factory created?

Bangladesh Machine Tools Factory was created on 1979-02-11.


What is the first task to be undertaken when setting and operating a center lathe?

The first task of operating a center lathe is to clean the area around it, the machine itself, and oiling the beds. But if you are asking what the first task is when the preparation of the machine and workplace is done, drawing and material collected, chuck replaced if necessary, cutting tools selected and set up, then the first task on the machine itself would be to clamp the workpiece in the chuck.


What are operating system tools called?

Utilities