0
What else can I help you with?
How do you build a rotating platform?
Take a drill and dismantle it then get a circular piece of wood, cut a hole in the middle, and fasten the drill to it, mount it to a base and get a sufficient power source
Why is it important to use a fixed common reference point for dimensioning of drawings and sketches?
It is important to use a fixed common reference point on your work peace or drawing to avoid cumulative error, i.e. if a hole is drilled using an incorrect measurement initially, then continuation to measure from the error instead of using a common reference point could result in a whole piece of work being scrapped. Also if somebody has to take over the work, they would need to understand were the dimensions were taken from to enable them to carry on with the work.
What is dry-liners?
In a dry liner the coolant runs in channels in the block, and the liner is only like a sleeve stuck in a metal hole. Poorer cooling, but an easier build.
H6 Tolerance for a 95mm hole?
H6 tolerance for 95 mm hole is +0.022/0
What is the tolerance for a 62mm H7 hole?
Tolerances H7 23DIA for hile is +0.021/-0.000 ///MUKI
Wjich of the following tools is used to mark the spot where a hole is to be drilled in piece of metal?
the small spaceabove the piston in which fuel burned is called the
When a hole is reamed in metal to size?
micro inces
How can a hole be drilled without using a drill?
A hole can be drilled without using a drill by using alternative tools such as a hammer and chisel, a rotary tool, or a heated metal rod to create a hole in a material. These methods require manual effort and may take longer than using a traditional drill.
What is a scriber?
A scriber is a tool used to etch something on a material. The scribes I've used are a pointed piece of metal you can use to do such things as make an indent on wood to mark where a hole is to be drilled.
What is a scriber tool?
A scriber is a tool used to etch something on a material. The scribes I've used are a pointed piece of metal you can use to do such things as make an indent on wood to mark where a hole is to be drilled.
What is a fusible plug?
A fusible plug is a metal cylinder that has been threaded with a hole drilled throughout it. The plugs can be found in a variety of metals. Heated metal is used to seal the hole.
What round file used for?
If a hole has been drilled in a metal sheet, the round file is used in the created hole to remove rough edges.
If you heat a piece of metal with a hole in the center how will the size of the hole change?
It would get larger due to the expansion of the metal (see the related links)
What is peep site?
A circular piece of metal with a hole in it.
How do you get wires from under the bonnet into the car?
Sometimes a hole may have to be drilled if the wires can not be passed through an existing hole. Be sure if a hole is drilled that all metal burs are removed and that the wires are wrapped well to prevent abrasion. Electricity and eventual bare wire caused by rubbing on metal over time will cause arcing and a possible fire.
What is the relevance of a dime coin 1875 drilled with a hole?
The relevance is some fool drilled a hole in it.
How do you spell bord?
Bored: I don't have anything to do. Board: a piece of wood. Bored: drilled or cut a hole in something.
