0
What else can I help you with?
How do you tighten 1985 Mercedes Benz SEC 500 door handle?
usually if you open the door, look in the door edge under the rubber seal right behind the handle you will see a screw, try to tighten it..
When I drive my VY commodore it sounds like there is rubber rubbing on rubber in either the doors or the dash. What could it be and how do i fix it.?
You will have to do some detective work to locate the source of the noise. Then adjust, tighten or lubricate what ever it is.
How do you make your wiper arm stop falling off the motor in your 1999 ford escort?
Tighten the nut on it below the rubber cup.
What could you use to clamp a rubber gas line?
You can use hose clamps to secure a rubber gas line. Make sure to choose a clamp that is the appropriate size for the diameter of your gas line and tighten it securely to prevent any leaks.
Where may oil leak from on 305 caprice classic engine?
Valve covers generally leak. Replace them with rubber valve cover gaskets,, not cork. Tighten bolts finger tight with 1/4 ratchet then 1/4 tirn to tighten down.
How do you put a new drain line into an old cast iron pipe?
You use a 'Robar' fitting, which is essentially a rubber sleeve with large hose clamps to tighten it.
How can I tighten a cassette without using a tool?
To tighten a cassette without using a tool, you can try using a rubber band or a piece of cloth to provide extra grip while turning it clockwise. This can help secure the cassette in place without the need for a specific tool.
How can I tighten a stripped screw?
To tighten a stripped screw, you can try using a rubber band or a piece of steel wool between the screwdriver and the screw head for better grip. Alternatively, you can use a screw extractor tool to remove the stripped screw and replace it with a new one.
Would a over tighten oil filter cause a leak?
It could if you crimp the gasket. Best bet is to remove it and install a new one. Put a little clean oil across the rubber gasket and clean the filter area on the engine. Tighten it as hard as you can BY HAND. It won't leak.
Do you need sealant to install a new valve cover gasket?
no the gasket should be rubber and should be bendable all you do is install it in the correct position and tighten the bolts in the right sequence
How do you adjust the emergency brake tension in 94 325i?
The parking brake cables are located directly beneath the handle. Pull off the rubber boot. Loosen the locknut and tighten the tensioner.
How do oil filters go on correctly?
If you are talking about a car's oil filter you want to tighten it to the point where the rubber gasket is touching, then turn it 3/4 of a turn beyond that. Do not overtighten it.Exactly! NOT too tightly! Put a small smear of grease on to the rubber O-ring, then tighten to a quite tight hand-tight. No more than that!If you are trying to remove a stubborn canister, either (i) use a strap-wrench or chain-wrench; or (b) puncture it with a screwdriver and use that as a lever.
