0
What else can I help you with?
How do you replace rear brake pipe to BMW 325ci?
how do you put disc brake bmw90 325i
Where is the clutch reservoir on a 1992 BMW 325i?
nxt to the brake reservior
How many coolant temperature sensor does a 2001 BMW 325i have?
A 2001 BMW 325i has two coolant temperature sensors. They constantly monitor the temperature and adjust flow as needed.
1990 325i cabriolet- brake light warning comes on all the time but lights check ok?
fault brake light switch, located at the top of the brake pedal.
I have a 1995 BMW 325i and I'm getting a brake light circuit message on my display panel. What does that mean?
If it says 'Brake Light Failure' or similar, your brake light is out. change the bulb.
Dash of BMW 2006 325i came on symbol a triangel and a flake on middle?
Could be your emergency lights/flashers are on.
How do i Replace rear brake pads on 2001 325i?
remove the hex bolt on the rotor and give it a smack with a mallet
Where is the clutch fluid reservoir for 1988 325i?
The clutch fluid is located in the same reservoir as the brake fluid. As a dot 4 brake fluid, used for the breaks and the clutch.
How do i replace brake pad sensor on a 2003 BMW 325i?
Carefully pry pad wear sensor from brake pad. Then insert brake pad wear sensor into cutout in new pad where applicable.
How many brake wear sensors are on a BMW 325i?
There are two. One for the front, and one for the back. I think that they are usually on the driver's side.
How do you reset disc brake warning light on 2004 325i?
To reset the disc brake warning light on a 2004 BMW 325i, you typically need to use a diagnostic tool or follow a manual reset procedure. If you have a diagnostic scanner, connect it to the OBD-II port and clear the fault codes. Alternatively, you can turn the ignition to the "on" position without starting the engine, then press the brake pedal three times. If the light persists, ensure that the brake pads are properly installed and that the brake fluid level is adequate.
What is 2006 BMW 325i brake fluid?
The 2006 BMW 325i uses DOT 4 brake fluid, which is a hydraulic fluid designed to provide the necessary pressure for the braking system. It's important to use the recommended fluid type to ensure optimal performance and safety, as different brake fluids have varying boiling points and properties. Regular maintenance includes checking and replacing the brake fluid to prevent moisture contamination and maintain braking efficiency. Always refer to the owner's manual for specific requirements regarding brake fluid for your vehicle.
