0
yes, styrofoam can be alternative scented glue..
because,.. i read ina certain article.. that Sony Corporation.. alreaday proved it.. :))
!!...
What else can I help you with?
How do you make a styrofoams as alternative scented glue?
Styrofoam extruded polystyrene(EPS),was invented in 1941 for the Dow building solutions company by chemist Ray McIntyre.
How do you build a strong tower made out of toothpicks and white glue?
Buy pieces of styrofoam. Then, you stick the base in styrofoam. Next, you measure the length of the first piece and the length of the shape of the toothpicks. You may put some vertical on the horizontal toothpicks. Cut off the top of the toothpicks, and put glue on them. If you just poke the next piece of the styrofoam on, you wouldn't be using the glue. Make sure the length of the styrofoam is slightly bigger than the shape of the toothpicks. Glue the styrofoam on. Lastly, do it over and over again until reached height desired. You will need • pieces of styrofoam • Over 100 pieces of toothpicks • Elmer's Glue-All glue
How do you make a 3d neon element?
with some Styrofoam balls glue them together and add ten protons/electron and ten neutrons
How do you make a model of mitochondria?
You can make it out of a ball styrofoam and cut it in half or however you like. You can glue clay or make it out of clay. Or even use those pipecleaners for the inside. :3
How do you make a mask out of a styrofoam ball?
The one I've seen is a Mardi Gras mask. Cut a paper plate in half. Glue (or staple) a craft stick to the lower corner of the flat side. Cut a slot to look through. Cut a 3" (or so) Styrofoam ball in half, glue glitter or paint with glitter paint, glue to paper plate just above the slot, as two eyes. Hold mask in front of face. If desired, paint or glue other face features on mask. Staple two craft pipe cleaners to the top of the mask as antenna.I have also heard that some people use a large Styrofoam ball as a base to make a papermache mask, which is then removed.See also, "How do you make a mask out of a sheet of Styrofoam?"
How do you make a model of a cracker?
Do some research and use Styrofoam. Cut it out, build it, and glue it. It doesn't matter how much. but Styrofoam is a good model source. You could also cut wood, but that might be a little time consuming for something so small.
How do you make a Styrofoam model of the Berlin wall?
you make the Styrofoam look like it
What is a good craft to make someone for Christmas?
What to make dad on Christmas? 1 there is a cool craft to make. You can get a flower pot and a Styrofoam ball big enough to fit in the hole of the pot. You will also need wooden sticks, as many as kids u have. pom poms, pipe cleaners, and a picture of each your kids. hot glue the Styrofoam ball in the hole of the pot. cut out the pictures and glue them on the wooden sticks. you may decorate the outside of the picture with any material. then wrap the pipe cleaners around the wooden stick. stab the sticks into the Styrofoam ball. hot glue the pom poms onto the Styrofoam ball. you may write or decorate the outside of the flower pot with any stickers or draw on it with markers. and walla you have your children's heads in a floor pot and it makes a wonderful mother's, father's, or Christmas present
What to make an Alamo model out of?
You glue all the sticks together and cut the edges to make them stand. make sure to put sticks all around. then you can design it.
What company makes styrofoam?
Dow Chemical company is the leading producer of Styrofoam. Styrofoam is used to make many things such as plates and cups.
How do you make Styrofoam Mosaics?
To make Styrofoam mosaics, start by cutting Styrofoam sheets into various shapes and sizes using a craft knife or hot wire cutter. Next, paint or cover each piece with colored paper, fabric, or markers to create your desired design. Once your pieces are ready, arrange them on a base like cardboard or a wooden board, securing them with glue. Finally, seal the mosaic with a clear adhesive or varnish to protect the surface and enhance the colors.
How do they make styrofoam?
using chemicals
