0
One thing that happens is the fan blades on the transmission get bent up into the drive belt and the fan blades throws the belt. The right way to fix is is to replace the fan, but you can bend the fan blades down by hand without removing anything and it seems to work just as well.
What else can I help you with?
Belt for craftsman tiller 917.292481?
A Craftsman belt number 9180R or a Gates belt number 6841
How can you get your Craftsman tractor blades to engage?
Fix the drive belt.
What belt numbers are need for craftsman mower model 917.273280?
The drive belt is a Craftsman #140294 The deck belts are Craftman #'s 180808 & 174368
What would cause the l belt replaced on a craftsman riding mower keep throwing the belt?
It might be the bearings are shot in your jack shaft.
Craftsman GT 5000 ground drive belt routing diagram?
The routing diagram for a Craftsman GT 5000 ground drive belt shows how the best must be wrapped around each pulley. It can typically be found on the underside of the housing or within the repair manual.
Why does your craftsman riding mower keeps chewing up the drive belt?
maybe your deck is too low
While cutting grass with craftsman riding mower you stopped and to go in different direction would not go after hearing a pop?
You have probably broken the drive belt. With the mower turned off, lie on the ground and look underneath the mower. There is a deck belt and a drive belt. The drive belt is the upper belt. Grab the upper belt and see if it is broken.
Drive belt from engine to mower deck on craftsman mower won't stay on idler pulley?
you probably have a bad bearing
How do you install ground drive belt craftsman model 917271030?
To install the ground drive belt on a Craftsman model 917.271030, first, ensure the mower is turned off and disconnected from power. Remove the deck by unscrewing the necessary bolts and detaching the belt from the engine pulley and idler pulley. Place the new belt around the engine pulley, then route it through the idler pulley and around the drive pulleys, ensuring it sits properly in the grooves. Finally, reassemble the deck and test the mower to ensure the belt operates correctly.
When you depress auger drive lever on sears craftsman snowblower it doesnt engage?
May possibly be a loose missing or worn belt.
What is the belt size for Craftsman lt2000?
94.5 in v belt.
What is the belt length of craftsman belt number 429636?
101.4"
