To remove a stone stuck in a bezel, first, carefully examine the bezel's edges for any visible debris or damage. Use a soft brush or a toothpick to gently dislodge any dirt or particles that may be causing the stone to stick. If the stone remains lodged, consider applying a small amount of lubricant, like petroleum jelly, to help it slide out. If these methods don’t work, it may be best to consult a professional jeweler to avoid damaging the piece.
If you are trying to replace you radio you would have to remove the bezel. Take the two knobs off, then gently pull off the bezel till it can't move (should be about a couple of inches then it gets stuck), follow the rod down towards the right side off the gas peddle and remove the two screws holding it. Now you can pull the bezel out further to disconnect the cables. Don't diconnect the rod from the back of the controls just unscrew it. if equipped with tilt steering tilt the column all the way down remove the steering column covers remove the screws at the top and bolttom of the instrument cluster bezel and detach it from the vehicle
there are two nuts on the bezel behind the dash. you can reach them from underneath.
To remove the rear light bezel on a 1992 Chevy Cavalier, start by opening the trunk and locating the screws or bolts securing the bezel. Remove these fasteners, typically found at the edges of the bezel. Once the screws are removed, gently pull the bezel away from the body of the car, being careful not to break any clips. Finally, disconnect any electrical connectors if necessary, and the bezel should come off easily.
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
To remove the dash bezel on a 2001 Jeep Wrangler, start by disconnecting the negative battery cable for safety. Use a flathead screwdriver to gently pry off the trim surrounding the bezel, then remove any screws securing the bezel in place. Carefully pull the bezel away from the dashboard, disconnect any electrical connectors for components like the hazard switch, and then fully detach it from the vehicle.
The panel for the heater under wind screen just clips in remove the panel and you will be able to remove the center bezel.
remove the screws from the black bezel surrounding the headlight, remove the bezel, remove the screws on the headlight retaining ring. pull headlight out, reverse for installation
pry up on the bezel around the shifter then remove 2 screws under bezel. remove 2 screws above radio faceing down remove ash tray remove radio bezel. move bolth seats up on the side of the ctr console is 2 screws remove then remove 2 screws in front of the shifter that are now showing after radio bezel is removed.remove screws located in cup holder crank up e brake and slide console out
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
Remove the 4 bezel trim phillips screws around trim bezel. Unplug headlamp socket. remove headlamp.install new. replace bezel with 4 screws. yur done.
To remove the dash bezel on a Saab 9-3, start by carefully prying off the trim pieces surrounding the bezel, using a plastic trim tool to avoid damaging the interior. Next, locate and remove any screws securing the bezel in place, typically found at the top and bottom edges. Once the screws are removed, gently pull the bezel away from the dashboard, being mindful of any clips or connectors. Finally, disconnect any wiring harnesses attached to the bezel before fully removing it.
the dash bezel is held in place with clips. you will need to carefully pull or pry the bezel loose and work your way around it.