The air mixture screw does that.
Due to the newer carb standards their is no universal rpm or settings for a weedeater you would have to contact a service center to look up the settings for your weedeater, they also normally take a special tool nowdays that you would have to have to adjust it.
Where is the nearest parts dealer/repair shop for Weedeater ?
i need to replace the flex shaft in my weedeater. how do i do it?
I want to Thread my weed eater RTE 115, BUT how do I do it?
To thread a weed eater is very simple and easy just takes a few steps. First you have to get the string and tie a knot in one end and then wrap it around into the other end of the weed eater and replace then cover then it should be go to go.
Weedeater products, or FeatherLite Weedeaters are made by Poulan. The web address in weedeater.com. There you will be able to put in the model number (ex. FL20), and select type 1. You will get an illustrated parts list and order any part you need.
whats the sparkplug gap on a featherlite fl 25 weedeater
To perform a weed eater spark plug replacement, first ensure the engine is cool. Locate the spark plug on the engine and use a spark plug wrench to remove it. Check the gap on the new spark plug and adjust if necessary. Install the new spark plug by hand, then tighten it with the wrench. Finally, reconnect the spark plug wire and test the weed eater to ensure it is running smoothly.
With a wrench.
If this is the 500 series Weedeater mower, try Walmart. They have this mower in stock.
It is possible that the oils would become airborne when shredded with a weed eater.
No, normally weedeater gas has oil mixed in with it. This will gunk up the engine and cause the spark plug to fail.