Plywood is the best choice between these two. Particle board can swell if water gets to it. You would be better off if you use a tile backer board. Concrete based or a fiber type. They are made for this application.
No, plywood alone is not strong enough for ceramic tile. These floors require a very sturdy subfloor at least 1 1/4" thick before the tile. This requires either using cement board or a pored mudbed.
The best way to repair particle board sub-flooring is to cut out the bad spot and replace with new board. You can only use vinyl and self stick tile over particle board. Ceramic tile cannot because the moisture in the thin-sets will break down the particle board.
Yes, tile can be laid on plywood, but it is important to ensure that the plywood is properly prepared and suitable for tiling to prevent issues such as cracking or shifting. It is recommended to use a cement backer board or an uncoupling membrane over the plywood before laying the tile to provide a stable and secure surface.
You couldn't tile directly over a plywood sub-floor because over time, the wood will be expanding. There are products you can use in between the plywood and tiles to keep them in place such as cement backer board.
To properly tile over a plywood subfloor, follow these steps: Ensure the plywood subfloor is clean, dry, and level. Apply a waterproofing membrane to prevent moisture damage. Install a cement backer board over the plywood for added stability. Use thin-set mortar to adhere the tiles to the backer board. Allow the mortar to dry completely before grouting the tiles. Seal the grout to protect it from stains and moisture. Following these steps will help ensure a successful tile installation over a plywood subfloor.
Yes, you can install ceramic tile over plywood, but it's essential to ensure the plywood is suitable for tiling. Use at least 3/4-inch exterior-grade plywood, and consider adding a cement backer board for a more stable and moisture-resistant surface. Proper preparation, including leveling and securing the plywood, is crucial to prevent cracking in the tile. Always follow manufacturer guidelines for the best results.
No because of a few of reasons. Most manufactured homes have particle board subfloors which are completely incompatible with installing ceramic flooring. In the rare event your floor doesn't have particle board and does have plywood, the house must be on a foundation. If it is in a park, it is usually held in place with tie downs. The home moves to much for the floor to be successful. Finally linoleum isn't an acceptable subfloor. You need a total of 1 1/4" of subflooring when complete. Assuming you have 3/4" plywood, you would need to add 1/2" cement board. The linoleum can stay, but the tile cannot be adhered directly to it.
I don't recommend it. The plywood is flexible and bends over time. Cover the plywood with Hardi Backer board first. Available in the tile department at Lowe's and Home Depot. Get the right screws for it. It's easy to install, comes in manageable size of 3 feet by 5 feet. Well worth the time, effort and money to make sure your tile job lasts.
Improper installation. You must install cement board over the sub floor before you tile. If the tile was glued to plywood which is not waterproof, the plywood will absorb moisture which will cause the grout to crack and deteriorate
Hardwood floors are generally more expensive than tile floors because they are harder to maintain. However, higher quality tile floors can cost more than hardwood floors.
Tile Steam Cleaning Restore Ceramic Tile Floors Clean Ceramic Tiles Cleaning Marble floors Kitchen Tile and grout Cleaning Residential Tile Cleaning Regrout Tile Floors Clean Granit Tile Cleaning Bathroom Tile Grout Pool Tile Cleaning
That depends upon location. Tiles can be installed on a gypsum board wall or ceiling. (But make sure that the tiles are well grouted; if moisure gets past the tile into the gypsum board, it will be damaged.) Floors require greater strength - but then, you wouldn't normally have a gypsum board floor, with or without tile.