Whitlam's Glue Wash dos melt ABS glue and easily takes it off skin. Due to this ,and the fact nothing else can do this, I certainly think it's worth a try on the carpet. What can you lose, it's already messed up with yellow glue.
Dip a rag in Goof Off and rub it on the carpet glue, it will soften enough to peel it off.
No, usually the varnish used on hardwood floors is resistant to turpentine. I would rather use Goof Off if I was removing carpet glue.
You should scrape the old glue off if you expect a flat surface.
That depends what kind of glue it is. -I would try Goof -Off for removing unknown glue from a carpet.
Carpet glue by its nature is extremely sticky as it is made to keep a rug from moving. If you need to get the glue off of a concrete floor you can use a floor grinder. You can also scrape it.
You heat the back of them with a hairdryer as you slowly pull it off.
usually not once it has been separated your best bet is to scrap off the old and lay brand new glue down, kyle carpet layer
To effectively dissolve carpet glue, you can use a commercial adhesive remover or a mixture of warm water and white vinegar. Apply the solution to the glue, let it sit for a few minutes, then scrape it off with a putty knife or scraper. Repeat as needed until the glue is fully dissolved.
It would help immensely if you said WHICH glue made the stains. As this was during plumbing, it may have been yellow ABS Glue, in which case your best remover is Whitlam's Glue Wash. -Rub the stains with a rag dipped in this and they should soften and come off -IF it's ABS glue.Next time please -Name your Glue -
To effectively remove carpet glue, you can use a solvent-based adhesive remover or a mixture of warm water and white vinegar. Apply the solution to the affected area, let it sit for a few minutes, then scrape off the softened glue with a putty knife or scraper. Repeat as needed until the glue is completely removed. Be sure to ventilate the area and wear gloves for safety.
To effectively remove carpet glue from wood surfaces, you can use a heat gun or a commercial adhesive remover. Apply heat to soften the glue and scrape it off with a putty knife. Alternatively, apply the adhesive remover according to the manufacturer's instructions and then scrape off the softened glue. Be sure to ventilate the area and wear protective gear when using these methods.