0
What else can I help you with?
Why is it difficult to unscrew a rusted nail?
I'm pretty sure you can't screw a NAIL. A screw maybe...
Is it possible to unscrew a rusted screw which is stuck?
well I have.......... so it means you can
How can I remove a rusted screw from a license plate?
To remove a rusted screw from a license plate, you can try using penetrating oil to loosen the rust. Let the oil sit for a few hours or overnight, then use a screwdriver or drill to carefully remove the screw. If the screw is still stuck, you may need to use a screw extractor tool or seek professional help.
Why is it important to replace a rusted license plate screw on your vehicle?
It is important to replace a rusted license plate screw on your vehicle because rust can weaken the screw, causing the license plate to become loose or fall off. This can lead to a safety hazard on the road and may result in a traffic violation. Regularly checking and replacing rusted screws helps ensure that your license plate remains securely attached to your vehicle.
Whythe mass of a rusted nail would be great than the mass of the nail before it rust?
Because a rusty nail still contains the same amount of iron that was present in the unrusted nail only it now contains the additonal weight of the oxygen which has combined with the iron to form rust.
Why can't I unscrew a screw?
There are several reasons why you may not be able to unscrew a screw. It could be due to the screw being stuck or rusted, the wrong tool being used, or the screw being stripped. It is important to use the correct tool and technique to avoid damaging the screw or the surface it is attached to.
Why can't I unscrew the screw?
There could be several reasons why you are unable to unscrew the screw. It could be due to the screw being stuck or rusted, the wrong tool being used, or the screw being stripped. It is important to use the correct tool and technique to avoid damaging the screw or the object it is attached to.
When a screw is brown does it mean its rusted?
It depends, if it is rough when you put your finger to it and slide it down the rim, (not fast though, if it IS rusty than it will cut you), then it is rusty. Try putting it in something or screw it on something, if you cant, its rusted.
How do you unscrew a very tight and rusted screw?
take it to a mechanic Soak it with a good penetrating oil, tap it with a hammer and if that fails apply heat.
How do you remove a rusted screw?
Depends on where and how rusted. WD-40 may help. Putting a screwdriver in the slot and hitting it once or twice with a hammer may break it loose if it is in something that will survive the hit. Heating it with a propane torch will loosen it if that is possible. Sometimes you have to drill it out and put a larger one in it's place. An impact screwdriver can be used. You beat on the end while turning the screw.
Why doesn't dome light come on on 1995 Geo Tracker?
I've run into this problem before there's a little switch at the bottom of the door pillar with one Phillips screw in it the wire may rust and break off or the groud screw gets rusted in my case it rusted inside of the buttoni baught some from a junk yard for 5 dollars took care of that problem.
How do you remove a distributor cap screw bolt rusted stuck without destroying distributor?
Most of the time it breaks off and you will need to drill it out and replace screew.
