0
What else can I help you with?
Where is the drive plate on a lathe?
Using a drive plate on a lathe requires removing the chuck and the drive plate is attached in its place onto the spindle.
What is a faceplate?
Face Plate is used on Lathe machine. It is just like lathe chuck. irregular shape job clamp on face plate by clamps, bolts.
What is the distance from backing plate to backing plate on a 1981 Chevy half ton truck?
good luck
What is the purpose of a backing plate on a brake?
On drum brakes the backing plate is what all the brake parts are mounted on. The springs, shoes, and wheel cylinder are all mooted to a stationary backing plate. On disc brakes the friction material or pad is glued or riveted to the baking plate.
Where can you find a backing plate for the passenger side mirror on a 1998 Honda Accord?
You can find a backing plate for your 1998 Honda Accord passenger side mirror at most auto-parts stores. You can also find the backing plate at your local Honda dealership.
What is a lathe indexing plate?
Simple indexing consists of a series of preset holes in a backing plate, these divisions are provided for the most common angles (such as 90 °, 45 °, 30 °, etc). The remaining divisions of a circle are provided by manually rotating the dividing arm using index plates. Tables or calculations are required to use this method. Indexing platesView showing simple indexing back plate*
How do you remove the right side rear backing plate of a 1992 Cadillac Sedan DeVille?
remove wheel remove brake drum remove brakes disconnect brake fluid line remove parking brake cable from backing plate remove four bolts attaching backing plate to axle housing remove wheel remove brake drum remove brakes disconnect brake fluid line remove parking brake cable from backing plate remove four bolts attaching backing plate to axle housing
How do you change the rear backing plates on 2002 escalade?
I am about ready to this on my 2004 Escalade. I am purchasing Split backing plate so I shouldn't have to pull the rear axle. I will loosen the 4 bolts that hold the axle and the backing plate in place. Once loose enough, I will cut out the old backing plate, shouldn't be too hard as they are already rotted substantially. I will be doing this in the next few days. Dan
What would cause a grinding noise in a Honda Accord after replacing front drive shafts?
You may very likely have bent the thin metal backing plate behind the brake rotor. That will cause the backing plate to rub against the rotor and make an awful grinding noise. Its not too hard to reform the backing plate away from the rotor.
How do you replace backing plate on a 1999 Chevy half ton with out having too remove axle?
you dont without cutting the plate
What are face plates used for on the lathe machines?
On a wood turning lathe, the faceplate is screwed to the piece of wood, then the faceplate is held in place by the chuck. This facilitates free-wheeling the opposite end for such items as bowls. Almost similar to a wood turning lathe, the face plate on a metal lathe is a device that is used instead of a chuck. It allows a workpiece to be clamped or bolted to it for machining.
Why use a backing plate for butt welding?
To support the molten metal while it is cooling
